ZAGI ZAGI-DC Assembly Manual - page 3

The Zagi-5C Kit Contents:

2

Expanded polypropylene (EPP) wing panels and beds

2

Pre-cut airfoil shaped balsa elevons

5

.03 X .31 X 24 Carbon fiber spars

1

Roll 2.2 mil color poly tape

2

Control horns with 2 screw plates and 4 screws

2

Threaded 2-56 control rods

2

Threaded 2-56 clevises

2

Die-cut clear plastic winglets

1

EPP foam block for repair and reinforcement

1

Roll of 2” wide fiber filament tape

1

2” x 5.5” Styrene electronics bay floor

Needed Components:

1

Receiver (RX)

2

Standard servos (cutouts are for “standard” servos but minis may be used)

1

Battery  A 600 mAh Nicad AA size battery will allow several hours of flying

before recharging.

Tools and Materials Needed:

Small 90 degree square

Sanding block

#150 to #320 grit sandpaper

X-acto knife with #11 blade

Dremel (optional)

Spray adhesive (3M Super 77)

Lead weights for balancing (if needed)

Additional roll 2.2 mil color poly tape in contrasting color (optional) - see text

Round pencil or ball point pen

Mixing (popsicle) sticks

Clear food wrap

Scissors

Z-bend pliers (optional)

3