ZALMAN CNPS7700 LED User Manual - page 6
※
The specifications of any product may change without prior notice to improve performance.
5
②
② Install Clip Supports for Socket 478
Install the clip supports for socket 478 on both sides
of the retention guide as shown in the diagram.
③
③ Install Grips and Bolts
Interlock the L-type grips with the clip. Insert the two bolts
into the inner holes of the grips.
④
④ Place FHS
Set the FHS at the center of the CPU. Screw the bolts
in slightly, and then tighten each bolt a few turns at a
time while alternating between the two until the clip
supports are completely pressed against the grips.
Retention Guide
Clip Support for Socket 478
⑤
⑤ Connect Power (How to use FAN MATE 2)
◆ Please refer to FAN MATE 2 Installation and Usage on page 7.
Bolt
Grip (L-Type)
Inner Hole
Grip (L-Type)
Clip Support for
Socket 478
2) Intel Pentium 4 - 478
①
① Apply Thermal Grease
Clean off particles and residue from the top of the
CPU then spread a thin layer of the included thermal
grease thoroughly on top of the CPU.
CPU (IHS)