ZALMAN CNPS9500 AT User Manual - page 5
※
The specifications of any product may change without prior notice to improve performance.
4
②
②
Install Clip Support
Align the Clip Support for Socket 775 (
⑥
) and the Backplate for Socket 775(
⑦
) with the mounting
holes of the motherboard and fasten them together by using the Clip Support Fixing Bolts (
⑤
).
The Lever Slot on the Clip Support (
⑥
) should be properly oriented on the hinged side of the Socket
Lever when installing.
※
※ The Backplate Support on the Backplate for Socket 775 (
⑦
) can be removed if deemed
unnecessary.
③
③
Apply Thermal Grease
Clean off particles and residue from the top of
the CPU. Then spread the included thermal
grease (
②
) on top of the CPU.
CPU
CPU
CPU
CPU
CPU
CPU
※ Note
Do not exert excessive force on the fan with the driver while installing.
Exerting excessive force on the fan can cause damage to the product.
Clip Support Fixing Bolt,
⑤
Clip Support for Socket 775,
⑥
Motherboard
Backplate for Socket 775,
⑦
Backplate Support
Socket Lever Hinge
Socket Lever
Socket Slot
CPU
CPU
④
④
Install Cooler
Insert two bolts (
④
) into the holes on the clip (
③
) and place CNPS9500 AT on the center of the CPU.
CNPS9500 AT must be aligned with the backside system fan in the same flow direction.
Slightly fasten the bolts (
④
) on the holes of the clip supports for Socket 775 (
⑥
), then fasten the
bolts in an alternating manner until the clip (
③
) is completely pressed against the clip supports.
Bolt,
④
Clip,
③
CPU (IHS)
Thermal Grease