ZANKER ZKK142U Instruction Manual - Maintenance

12

Maintenance

Unplug the appliance before carrying out

any maintenance operation.

Defrosting

¥ During normal operation, the evaporator in the

refrigerator compartment will gradually become

covered with frost.

¥ It is important to periodically 

remove the frost.

To defrost, proceed as follows:

¥ press the button in the centre of the thermostat

knob.

¥ Once defrosted, the refrigerator will start up again

automatically; the defrosting water which has

collected in the tray below the evaporator must

however be removed.

Never use sharp metal tools to scrape off

frost from the evaporator as you could

damage it.

Do not use a mechanical device or any

artificial means to speed up the thawing

process other than those recommended by

the manufacturer.

Cleaning

Never use metal objects for cleaning your

appliance as it may get damaged.

NEVER use detergents, abrasive powders,

highly perfumed cleaning products or wax

polishes to clean the interior as these will

damage the surface and leave a strong

odour.

Clean the inside with warm water and bicarbonate of

soda. Rinse and dry thoroughly.

When the appliance is not in use

Disconnect the appliance from the electricity supply.

Empty all foods and clean the appliance, leaving the

doors ajar to prevent unpleasant smells.

Changing the light bulb

¥ Should the interior light fail to work, first switch off

the appliance and disconnect from the electricity

supply, then replace the 

bulb.

¥ The opening on the diffuser gives access to the

light bulb.

¥ Replace the bulb by other with another with the

same charcteristics.