- DL manuals
- ZANKER
- Dishwasher
- ZKS5430I
- Instruction Book
ZANKER ZKS5430I Instruction Book
Summary of ZKS5430I
Page 1
Geschirrspüler zks 5430 i dishwasher bedienungsanleitung seite 2 instruction book page 18 d gb.
Page 2: Contents
Safety instructions 19 disposal 19 economical and ecological dishwashing 19 installation instructions 20 building-in 20 levelling 20 fixing to the adjacent units 20 water supply connections 20 water inlet hose with safety valve 20 water outlet hose connection 21 electrical connection 21 description ...
Page 3: Disposal
It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new own...
Page 4: Installation Instructions
Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Remove all packaging before positioning the machine. If possible, position the machine next to a water tap and a drain. Building-in this dishwas...
Page 5
Water outlet hose connection the end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. 2. Hooked over the edge of the sink using the special c...
Page 6: Description of The Appliance
Description of the appliance 22 1. Upper basket stop 2. Water hardness dial 3. Salt container 4. Detergent dispenser 5. Control panel 6. Rating plate 7. Rinse aid dispenser 8. Filters 9. Lower spray arm 10. Upper spray arm 11. Upper basket in155 the control panel programme guide on/off button bio - ...
Page 7
Before using your dishwasher for the first time: 1. Ensure that the electrical and water connections comply with the installation instructions 2. Remove all packaging from inside the appliance 3. Set the water softener 4. Pour 1 litre of water inside the salt container and then fill with dishwasher ...
Page 8
Rinse aid rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting...
Page 9: In Daily Use
● check if it’s necessary to refill with dishwasher salt or rinse aid ● load cutlery and dishes into the dishwasher. ● fill with dishwasher detergent . ● select a wash programme suitable for the cutlery and dishes. ● start the wash programme. Loading cutlery and dishes sponges, household cloths and ...
Page 10
The upper basket the upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces. Glasses with long stems can be placed upside down in the cu...
Page 11: Different Kinds of Detergent
Detergent tablets detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets cannot dissolve and develop their full cleaning power during short programmes. Therefore please use long programmes when using detergent tablets, to ensure the complete remova...
Page 12: Washing Programmes
(1) testing programme for en 50242 (see "hints for test centres"). This programme, developed for the use of detergents with enzymes, allows you to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°c programmes and conventional det...
Page 13: Starting A Washing Programme
In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be open. 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Turn on the water tap 3. Setting and starting a programme turn ...
Page 14: Maintenance and Cleaning
Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). Ensure that the seals around the door, the detergent and rinse aid dispensers are...
Page 15: What to Do, When...
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. ...The wash results are not satisfactory the dishes are not clean ● the wrong washing programme has been selected. ● the dishes...
Page 16
If after all these checks, the problem persists, contact your local service force centre, quoting the model (mod.), product number (pnc) and serial number (s.N.). This information can be found on the rating plate located on the side of the dishwasher door (see picture). So that you always have these...
Page 17: Hints For Test Centres
Testing in accordance with en 60704 must be carried out with appliance fully loaded and using the test programme (see "washing programmes" chart). Test in accordance with en 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectivel...
Page 20
Änderungen vorbehalten subject to change without notice 152960 21/0 09/04.