ZANKER ZKS5450I Instruction Book - Building-In
PII15GB
31
BUILDING-IN
Building-in features
This dishwasher is designed to be fitted under a kitchen
counter or sink.
In either case, it is essential that the recess dimensions
indicated in the picture are followed.
No further openings for venting of the dishwasher are
required, but only to let the water fill and drain hoses
and power supply cable pass through.
The recess height may be anywhere between 820 and
880 mm from the floor since the dishwasher incorporates
levelling feet adjustable over a wide range (max 60 mm).
Adjust the height of the appliance by turning these feet.
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
Fitting the vapour protecting strip
Screw the vapour protect-
ing strip onto the front part
pf the worktop using 3.5 x 16
screws.
Fitting under a counter (kitchen worktop
or sink)
It is absolutely essential that the dishwasher is
disconnected from the electricity supply before gaining
access to any internal component.
Fitting the sealing strips to the sides of the
appliance
To ensure closer contact with
the adjacent kitchen units, fit
the plastic sealing strips
down both sides of the front
of the machine before insert-
ing it into the recess.
Fit the dishwasher into the appropriate housing space
and connect it. Make sure that the water fill and drain
hoses and the power supply cable are not bent or kinked.
Fitting the panel onto the door
The door on this model is designed for the overlay of
a panel having the following dimensions:
Width:
446 mm
Height:
644 to 714 mm max
Thickness:
20 mm max
Weight:
1.5 to 6 kg max
Note:
The panel height should not be more than what
indicated, otherwise complete opening of the door will
no longer be possible as the panel hits against the
dishwasher plinth.
Mounting of decor panel onto the door
The height of the panel depends on the height of the
plinth of adjacent kitchen units (see kitchen plinth
adjustment).
The panel must be fitted
with a handle, as the dish-
washer handle will be hid-
den by the panel.
Drill the panel with a Ø 2 x 12
bit according to the dimen-
sions indicated in the figure.
Fix the cross bar onto the panel using four 3.5x16
screws provided. Reduce the length of fixing screws
according to thickness of panel.
If for aesthetic matching the panel is provided with a
false drawer (fitted or carved on the panel itself), the
two brackets provided should also be used.
Fix the brackets according to
the measurements shown in
the figure, by using four 3.5 x
16 screws.
Mount the decor panel by
inserting the two pivots of
the cross-bar into the slot-
ted holes of the door.
Lift the decor panel until
perfect alignment with the
facia panel is obtained: if
the two brackets have also
been used, they will auto-
matically enagage in the
special holes provided on
the dishwasher door.
818
÷
878
555
446
450
820
÷
880
II33
max
0
÷
60mm
II06
148
446 max
360
30
II27
*
*
450 mm
450 mm
II37
A
A
A
A
II23
40
446 max
391,5
=
=
30
40
30
II26
II12