ZANKER ZSK3502X Installation And Operating Instructions Manual - page 10
25
Installation Instructions
Safety Instructions
The appliance is only to be connected to
the mains by a qualified electrician. The
proper connection of the appliance to the
mains is to be certified on page 14 as proof for
use in the event of a claim under the warranty.
Important! Zanker built-in switch boxes may
only be combined with glass ceramic cooking
surfaces or hobs in accordance with the Table
of Combinations. The usage of other glass ce-
ramic cooking surfaces and hobs excludes any
liability on the part of Zanker. The approvals re-
lated to the test markings are invalid if this in-
struction is not observed.
The appliance must be isolated from the mains during
installation and servicing; remove or switch off the
fuse.
The general directives on the operation of electrical
appliances, the regulations of the local electricity bo-
ard and the information contained in these installation
instructionsare to be fully observed.
Unpacking
Check that the appliance has been delivered
undamaged. Appliances with obvious trans-
port damage must not be connected to the
mains.
Installation in Kitchen
Units
Electrical safety is to be assured by correct in-
stallation.
A removable intermediate panel is necessary under-
neath the switch box. If installed away from the wall,
the rear wall of the switch box must also not be accessi-
ble.
Protection against touching in accordance with VDE
regulations must be assured by proper installation of
the appliances in suitable units that comply with the
standards . Kitchen units must be installed and faste-
ned such that they are safe from tipping.
Remove any protective sheeting on the appliance prior
to using for the first time.
Abb.3
100 mind
Abb.4
35 mind