Zanussi DES 959 Instruction Booklet - Operating Sequence
16
1.
Press the On/Off push button
The On/Off indicator light comes on, also the
indicator lights of the last selected programme
and relative options come on.
2.
Check that
there is rinse aid and salt
The corresponding indicator lights will illuminate
if refilling is necessary.
3.
Open the door and check the
filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
4.
Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5.
Ensure that the spray arms can
rotate freely.
6.
Measure out detergent
Add the required amount of detergent into the
dispenser.
Close the detergent dispenser lid.
Important!
If "half load" option is selected remember to
reduce the quantity of detergent
7.
Close the dishwasher door
8a. Setting and starting the
programme without "delay
start"
Press the push button corresponding to the
desired programme. The indicator lights of
the programme and all the phases the
programme consists of will come on. In the
digital display appears the duration (in
minutes) of the programme.
●
Select if necessary the washing on only one
basket by pressing the half load push
button.
Remember to load all dishes into the
selected basket.
Press "programme start" push button, an
audible signal advises you that the
programme has started.
The display will show the running time
of the programme and the indicator lights of
the phases will turn off except for the
indicator light of the current phase.
The time in the digital display will start to
decrease from minute to minute.
If the door is opened during the run of the
programme the current phase will be
interrupted and the indicator light of the
interrupted phase will start to flash.
Once the door is closed the programme will
start from the point where it was interrupted.
SEQ32en