Zanussi DW 929 Instruction Booklet - page 21

21

Water outlet hose connection

The end of the drain hose can be connected in the

following ways:

1. To the sink outlet siphon, securing it if necessary 

with a clip.

2. Hooked over the edge of the sink using the special 

curved plastic guide provided.

3. To a stand pipe provided with vent-hole, minimum 

internal diameter 4 cm.

The waste connection must be at a height of between

30 cm (minimum) and 100 cm (maximum) from the

bottom of the dishwasher.

The drain hose can face either to the right or left of the

dishwasher 

Ensure the hose is not bent or squashed as this could

prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer

than 2 metres and its internal diameter must be no

smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used

for connections to the waste outlet must be no smaller

than the diameter of the hose provided.

The sink plug must not be in place when the

machine is draining as this could cause the water

to siphon back into the machine.

COL09en

min 30 cm

max 100 cm

min 4 cm

Ø 21

Ø 18

CS09

2

3

1

max 100 cm

min 30 cm

max 100 cm

max 100 cm

+ 2 m max

CS10

Ø 18

Ø 21