Zanussi Electrolux IZ12 Instruction Booklet - page 11
79
ENGLISH
• Draining and spin:
- Press the START/PAUSE button. The machine
will drain the water, then spin the laundry at the
maximum speed provided for the selected
programme.
- Select spin speed by means of button 5, and
press the START/PAUSE button.
• Drain only
- Press the ANNUL.
button once, so as to cause
the DRAIN
light to light up, then press the
START/PAUSE button.
Important! If you accidentally press the ANNUL.
button more than once, the display will show three
blinking dashes. To drain the water, select any
washing programme by means of the TEXTILE
button, then press ANNUL. three times in order to
select the DRAIN
position (only the DRAIN light
will remain lit).
6 OPTIONS button
Press this button to select the following options:
• PREWASH: select this option if you wish your
laundry to be prewashed before the main wash (not
available for wool and hand-wash cycle).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics,
whereas in the programme for delicate fabrics the
water is only drained.
• EXTRA RINSE
: this option can be selected with
all programmes except the wool programme and
hand wash. The machine performs 4 rinses instead
of 3. This option is recommended for people who
are allergic to detergents, and in areas where the
water is very soft.
7 TIME SAVE button
This button allows you to select the QUICK WASH
function, for laundry that is only slightly soiled (not for
wool and HAND WASH programme).
The washing time will be reduced according to the
type of fabric and the selected temperature.
8 Display
The following pieces of information are shown on the
display:
• Three blinking dashes, when a programme is
cancelled by means of the ANNUL. button.
The three blinking dashes will also appear when you
press the ON/OFF button to switch the machine on, if
the previously selected cycle has been erased.
• Duration of washing programme in hours
and minutes, after you have selected a programme.
While the programme is running (after you have
pressed the START/PAUSE button), the displayed
time value decreases by one unit every minute.
• The washing machine has stopped with water in
the tub, at the end of a programme with the RINSE
HOLD
option: this is indicated by a static zero.
• The washing machine has completed the
programme: this is indicated by a blinking zero. At
the same time, the door locked light goes out. The
zero will reappear when you switch the washing
machine on, unless the previous programme has
been erased by means of the ANNUL. button.
0
2.05
---
132990080.qxd 01/12/2003 15:45 Pagina 79