Summary of ZHC935
Page 1
Cooker hood zhc 935 instruction booklet.
Page 2
2 customer care department zanussi 55 - 77 high street slough berkshire sl1 1dz tel: 08705 727 727 to register ownership, please ensure you complete and return the guarantee card sup- plied with the appliance. Thank you for buying a zanussi product. To enable you to use your appliance effectively an...
Page 3
3 these warnings are provided in the interests of safety. Ensure that you understand them all be- fore installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the customer care department. • installation • any ...
Page 4: Your Appliance
4 your appliance this cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Cooker hood controls the cooker hood functions are controlled by five push button switches located centrally in the control fascia. L push to switch on the worktop lighting. S red ...
Page 5
5 to operate select the required fan speed and light if required. The appliance can be installed to recirculate or extract contaminated air. The cooker hood is more effective when used in the extraction mode. Recirculation the cooker hood is supplied specified for use in the recirculation mode with ...
Page 6: Maintenance And Cleaning
6 before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External cleaning the metal casing, visor and chimney should be cleaned at least once a month to keep the hood loo...
Page 7: Maintenance And Cleaning
7 maintenance and cleaning charcoal filter the charcoal filter cannot be cleaned or regenerated, it should be replaced approximately every three months or more frequently if the hood is used for more than three hours per day. To remove the charcoal filter remove the metal grease filter. Release the ...
Page 8: Something Not Working
8 if, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Something not working symptom the cooker hood will not start • check the hood is connected to the electricity supply. • make sure the switch is in the ‘on’ position. • t...
Page 9: Guarantee Conditions
9 guarantee conditions we, zanussi, undertake that if within twenty four months of the date of the purchase this zanussi built-in product or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same free o...
Page 10: Installation Instructions
10 installation instructions it is dangerous to alter the specifications or attempt to modify this product in any way. Technical information dimensions height of canopy: 73mm height of chimney:(upper section) 215mm (lower section) 740mm width of canopy: 898mm depth of canopy: 500mm weight: (gross) 2...
Page 11: Installing The Cooker Hood
11 please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. Installa...
Page 12: Installing The Cooker Hood
12 clearance heights the cooker hood is designed to be fitted over a cooking appliance at the clearance heights stated, providing the maximum output of the appliance beneath does not exceed the maximums quoted in the technical specifications. If the output of the appliance below the cooker hood exce...
Page 13: Installing The Cooker Hood
13 fitting the wall brackets draw a vertical line on the wall from the centre of the cooking appliance up to the ceiling, or as high as the adjoing wall cabinets using a spirit level and marker pen. This is to ensure the correct vertical alignment of the appliance. - draw a horizontal line 965mm abo...
Page 14: Installing The Cooker Hood
14 rear splashback (optional) the splashback comes in two parts, the back panel and the top profile, which fits between the top of the splashback and the underside of the hood. The splashback and the profile must be fitted before fixing the canopy. Installation is rather complex and should be undert...
Page 15: Installing The Cooker Hood
15 ducting the cooker hood when installing the cooker hood in the ducting mode, connect the hood using either Ø150 or 120mm flexible or rigid pipe. The choice of ducting should be specified by the installer but Ø150mm rigid ducting will ensure the best performance possible. The ducting used must be ...
Page 16: Installing The Cooker Hood
16 fitting the chimney stack the chimney consists of two sections. The upper chimney measures 215mm and the lower chimney (with the holes for recirculation on either side) measures 740mm. - upper chimney stack - expand the sides of the upper chimney stack item 2.1 and place the chimney over the two ...
Page 17
17.
Page 18
18.
Page 19
19.
Page 20
436000659 01 - 020415 © electrolux household appliances limited 2001.