Zanussi Electrolux ZWT6021 User Manual - page 9
how to run a wash cycle 9
Selecting the spin speed
Press the “Spin” pushbut-
ton to change the spin
speed, if you want your
washing to be spun at a dif-
ferent speed to the one se-
lected by the appliance. You
can also select “No spin”*,
“Rinse hold”
*
or “Night si-
lence plus”*.
The maximum speed is 600 rpm for all
the programmes.
At the end of the programme, if you have
selected “Rinse hold”
or “Night silen-
ce plus”, you then need to select a
“Spin” or “Drain” programme to fi-
nish the cycle.
“Rinse hold”
The washing machine will not drain the
water from the last rinse, so will not
crease the laundry.
Selecting options
You must select the
different options after
selecting the pro-
gramme and before
pressing the “Start/
Pause” pushbutton
(see “Programme table”). Press the de-
sired button(s) ; the corresponding lights
come on. If pressed again, the lights go
out. If one of the options is not compati-
ble with the selected programme, the
“Start/Pause” pushbutton flashes red.
“Prewash” option
The appliance runs a prewash at 30°C
max. The prewash finishes with a short
spin cycle for cotton or synthetic pro-
grammes, and with an empty cycle for
delicates programmes.
“Light/Super quick” option
The cycle can be made longer or shorter
by pressing the “Option” pushbutton to
choose “Light” or “Super quick”. By de-
fault, all indicators are switched off.
Light : Lightly soiled laundry
Super quick : Very lightly soiled laundry
or half load
The availability of these different levels
varies depending on the selected pro-
gramme type.
“Extra rinse” option
The washing machine will add one or
more rinses during the cycle.
This option is recommended for people
with sensitive skin and in soft water
areas.
• Temporary :
Press the “Extra rinse” pushbutton
.
The option is only active for the selected
programme.
• Permanent :
Hold down the “Spin” and “Option”
pushbuttons for a few seconds. The op-
tion is permanently activated, even if the
appliance is switched off.
To deactivate it, repeat the process.
*depending on model