Zanussi Electrolux ZWV 1651S Instruction Booklet - 7 Start/pause Button
11
CONTRAST
The Contrast setting allows you to modify the optical
characteristic of the display.
Example:
1. Enter the Menu option and select the Contrast
setting.
2. Use the Change button to set up the desired
contrast level.
BRIGHTNESS
The Brightness setting allows you to modify the
backlight intensity of the display.
Example:
1. Enter the Menu option and select the Brightness
setting.
2. Use the Change button to set up the desired
brightness level.
Note:
At the end of the programme if no button is pressed for
approximately 10 minutes the backlight intensity goes off.
7 START/PAUSE button
This button has 2 functions:
Start/
Pause
Change
Options
Exit
Brightness
B
Temp.
Spin
Change
Options
Exit
Brightness
A
Temp.
Spin
Change
Options
Exit
Contrast
B
Temp.
Spin
Change
Options
Exit
Contrast
A
Temp.
Spin
•
Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light close to the button will stop
flashing and remain lit.
If you have selected a delay time option, the countdown
will begin and will be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light close
to the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, it becomes possible to
open the door if:
•
The washing machine is not in the heating phase;
•
The level of the water is not high;
•
The drum is not turning.
Important!
You must set the washing machine to PAUSE before
you make any change in the programme in progress.
8 Vocal messages
An electronic vocal board helps you through all the wash
process, with its clear, simple and helpful messages.
The vocal messages can be activated or disactivated,
pressing simultaneously the buttons Change and Exit.
If it is activated on the display is written “Voice enable”.
If it is disactivated on the display is written “Voice
disable”.
It is possible the select three different levels of volume
(LOW, MEDIUM and MAXIMUM), by pressing the
Change button, entering in MENU and then on setup
option.
When the appliance is switched on, a friendly jingle can
be heard.
There are two kind of messages:
●
messages explaining how to set a washing
programme up and describing the different options.
The messages can be heard only once some seconds
after a new selection.
●
warning messages.
In these case, the messages are played immediately and
repeatedly until the cause is removed.
Note!
This vocal board can speak several languages. You can
choose the machine speaking language in the same way
you select the one appearing on the display. If you
choose a language not provided, no message is played.
132985260.qxd 22/06/2005 09:35 Pagina 11 (Nero/Process Black pellicola)