Summary of FCS 1020 C
Page 1
En user manual 2 washing machine fcs 1020 c.
Page 2
Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 before first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 helpful hints and tip...
Page 3
• always be sure, that there is no water leakage from hoses and their connections after the installation. • if the appliance is installed in a location subject to frost, please read the “dangers of freezing” chapter. • any plumbing work required to install this appliance should be carried out by a q...
Page 4
Machine front 1 2 3 4 1 detergent dispenser drawer 2 control panel 3 door opening handle 4 adjustable feet (front) machine rear 1 3 2 4 1 transit locking devices 2 drain hose 3 electrical lead 4 inlet hose detergent dispenser drawer compartment for powder or liquid detergent used for main wash. If u...
Page 5
Control panel 1 2 3 4 5 6 8 9 7 henceforth, the programme selector dial, the spin selector dial, programme progress lights and different buttons will be indicated in all the book with the relevant numbers given in this table. 1. Detergent drawer • detergent drawer has 2 separate compartments for det...
Page 6
9. Programme selector dial and on/off switch • the programme selector dial allows to select a programme and/or to reset, cancel the programme, switch the machine on/off. • programme selector dial is divided into following sections: cotton, syn- thetic, delicate, wool, special programmes. It can be t...
Page 7
(a) (b) (c) (d) (e) the light a illuminates when the machine is performing the washing phase . The light b illuminates when the machine is rinsing . The light c illuminates when the machine is spinning . The light d illuminates at the end of the washing cycle. The light e indicates if the door can b...
Page 8
On programme progress display the pilot lights corre- sponding to all phases composing the selected pro- gramme are lit. On position the programme is reset and the machine is switched off. At the end of the programme the selector dial must be turned to position to switch the machine off. Important! ...
Page 9
• select the «drain» or «spin» programme • press button 6 when the pilot light e goes out, the door can be opened and the laundry can be removed. At the end of the cycle, turn the programme selector dial to to switch the machine off. Remove the laundry from the drum and carefully check that the drum...
Page 10
Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Gra...
Page 11
Washing programmes programme/ temperature type of laundry options description of the pro- gramme cotton 90° white cotton (heavily soiled cotton items) spin reduction/no spin/rinse hold extra quick/quick 1) prewash economy super rinse main wash rinses long spin max. 1000 rpm max load 3 kg cotton 60° ...
Page 12
Programme/ temperature type of laundry options description of the pro- gramme spin separate spin for hand washed garments and after programmes with the rinse hold option selected. You can choose the spin speed by turning the spin speed selector to adapt it to the fabrics to be spun. Spin reduction d...
Page 13
Cleaning the drawer recess having removed the draw- er, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme with- out any clothes in the drum. Cleaning the water inlet f...
Page 14
Problem possible cause/solution the machine does not start: the door has not been closed. • close the door firmly. The plug is not properly inserted in the power socket. • insert the plug into the power socket. There is no power at the socket. • please check your domestic electrical installation. Th...
Page 15
Problem possible cause/solution unsatisfactory washing results: too little detergent or unsuitable detergent has been used. • increase the detergent quantity or use another one. Stubborn stains have not been treated prior to washing. • use commercial products to treat the stubborn stains. The correc...
Page 16
Mod. ... ... ... Prod. No. ... ... ... Ser. No. ... ... ... Technical data dimensions width height depth 67 cm 49,5 cm 51,5 cm electrical connection voltage - overall power - fuse information on the electrical connection is given on the rating plate, on the inner edge of the appliance door. Water su...
Page 17
Programme energy consumption (kwh) water consumption (litres) programme duration (mi- nutes) spin - - ~ 5 1) «cottons + eco option» at 60°c with a load of 3 kg is the reference programme for the data entered in the energy label, in compliance with eec 92/75 standards. The consumption data shown on t...
Page 18
With a suitable spanner unscrew and remove the three screws and their spacers on machine's rear. The three holes must then be plugged with the plastic plug caps supplied in the bag containing the in- struction booklet, which can be found inside the drum. Positioning install the machine on a flat har...
Page 19
650-800 mm the drain hose can be connected directly into the pipe (e.G. Beneath a washtub or sink), above the water trap. The drain hose must be arranged so that some part of it’s length is routed up to a level corresponding to the top edge of the tub and fixed in place there. Directly into a drain ...
Page 20
>pp this means that they can be recycled by disposing of them properly in appropriate collection containers. Ecological hints to save water, energy and to help protect the environment, we recommend that you follow these tips: • normally soiled laundry may be washed without pre- washing in order to s...
Page 21
21.
Page 22
22.
Page 23
23.
Page 24
Www.Zanussi.Com 192 99 687 1-00 -312 00 9.