Zanussi GAS HOB ZGG 659 Instruction Booklet - Important Safety Information

Manual is about: Zanussi Cooktop User Manual

Summary of GAS HOB ZGG 659

  • Page 1

    Gas hob zgg 659 instruction booklet il.

  • Page 2: Important Safety Information

    2 important safety information you must read these warnings carefully before installing or using the appliance. Installation z this appliance must be installed by qualified personnel, according to the manufacturer’s instructions and to the rules in force. Z remove all packaging before using the appl...

  • Page 3: For The User

    3 for the user description of the appliance page 4 operation page 5 maintenance and cleaning page 6 something not working? Page 7 contents for the installer engineers technical data page 7 installation page 8 gas connection page 8 building in page 9 fitting the hob to the worktop page 10 electrical ...

  • Page 4

    4 description of the appliance installation any gas installation must be carried out by qualified personnel, and in accordance with existing rules and regulations. The relevant instructions are to be found in the second section of this manual. Please, ensure that, once the appliance is installed, it...

  • Page 5: Hob Burners Control Knobs

    5 hob burners control knobs the symbols on the hob burners control knobs mean that: z there is no gas supply there is maximum gas supply there is minimum gas supply lighting the burners for easier lighting, proceed before putting a pan on the pan support. To light a burner: z push in the relevant kn...

  • Page 6: Maintenance and Cleaning

    6 maintenance and cleaning before any maintenance or cleaning can be carried out, you must disconnect the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The hob top regularly wipe over the hob top a...

  • Page 7: Engineers Technical Data

    7 overall dimensions width: 580 mm depth: 510 mm height: 88 mm weight: 12,5 kg instructions for the installer cut out dimensions width: 550 mm depth: 470 mm thickness: 30 mm supply connections gas: rc 1/2 inch (1/2 inch male) rear right hand corner electric: 230-v 50hz supply, 3 core flexible cable ...

  • Page 8: Installation

    8 a) end of shaft with nut b) washer c) adjustable joint installation important this appliance must be installed by qualified personnel. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Gas connect...

  • Page 9: Building In

    9 building in 30 20 min 60 a b fo 1013 building over a cupboard or drawer if the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. Building over a kitchen unit with door proper arrangem...

  • Page 10: Fitting The Hob to

    10 before fitting the hob into the cut out, an adhesive seal must be fitted to the underside outside edge (see figure 6) of the hob. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below. 1) remove the pan supports, the burners ca...

  • Page 11: Commissioning

    11 commissioning fig. 8 by-pass screw when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from ...