Zanussi IZ 10 User Manual - page 13
ENGLISH
Important!
You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
•
Draining of water and spinning
after the
execution of programmes with the NIGHT WASH
(CICLO NOCHE) option.
10 RESET (ANULAR) button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear and the audible warning signals relevant to
the end of the previous cycle will be given.
You can also press the RESET (ANULAR) button to
exclude one or several phases of the programme
which is running, as indicated below.
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the RESET (ANULAR) button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the name of the phase(s) will go out).
Example:
In this case, the spin
(at the speed provided
for the selected type of
fabric) will be
performed.
This button allows you also to select special
programmes, such as
RINSES
,
SPIN
and
DRAIN
.
•
If the machine is already switched on
because it
has just performed a washing programme, proceed
as follows:
- depress RESET (ANULAR) once or repeatidly to
cancel the previously performed programme (three
blinking dashes will appear on the display);
- select the type of fabric by means of button
TEJIDOS;
- select the special programme:
•
RINSES
Depress RESET (ANULAR)
once
, the pilot light
WASH goes out.
•
SPIN
Depress RESET (ANULAR)
twice
, the pilot lights
WASH and RINSES go out.
PREWASH
PRELAVADO
WASH
LAVADO
RINSES
ACLARADOS
SPIN
CENTRIFUGADO
DRAIN
DESCARGA
•
DRAIN
Depress RESET (ANULAR)
three times
, the
pilot lights WASH, RINSES and SPIN go out.
Example:
In this case the
machine will perform
the rinses and spin.
•
If the machine is switched off:
- depress ON/OFF button to switch it on;
- select the type of fabric by means of button
TEJIDOS:
- select the special programme as previously
described.
11 DELAY (INICIO DIFERIDO) button
This button makes it possible to delay the starting of
the programme by up to 24 hours. The delay you
have selected is shown on the display for about 3
seconds; afterwards, the duration of the programme
reappears.
You must select this option
after
you have set the
programme and
before
you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment
,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to
change
or
cancel
the delay
time, proceed as follows:
• set the washing machine to PAUSE by pressing the
START/PAUSE button;
• press the DELAY button until the display shows the
desired delay time or
• press the DELAY button once, to erase the delay
time. The display will indicate “0h”.
• press the START/PAUSE button again.
PREWASH
PRELAVADO
WASH
LAVADO
RINSES
ACLARADOS
SPIN
CENTRIFUGADO
DRAIN
DESCARGA
37
132993440.qxd 10/21/02 3:47 PM Pagina 37 (Nero/Process Black pellicola)