Gas hob models pwl 59 pxl 59 instruction booklet il 35687-8901.
2.
3 for the user contents guide to use the instructions the following symbols will be found in the text to guide you throughout the instructions: safety instructions step by step instructions for an operation ) ) ) ) ) important safety information you must read these warnings carefully before installi...
4 1. Hob top 2. Triple crown burner 3. Semi-rapid burners 4. Auxiliary burner 5. Control knob for back right burner (semi-rapid) 6. Control knob for back left burner (semi-rapid) 7. Control knob for front left burner (triple crown) 8. Control knob for front right burner (auxiliary) 1 3 2 3 descripti...
5 operation this hob is provided with a safety device, which will stop the gas flow if the flame accidentally goes off during cooking. To light a burner: - turn the relevant control knob anticlockwise to maximum position and push it down to ignite; - upon ignition, keep the knob pushed down about 5 ...
6 maintenance and cleaning before any maintenance or cleaning can be carried out, you must disconnect the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The hob top regularly wipe over the hob top u...
7 solution check that the unit is plugged in and the electrical supply is switched on. Check the mains fuse has not blown. Check the burner cap and crown have been replaced correctly, e.G. After cleaning. Check the main jet is not blocked and the burner crown is clear of food particles. Check the bu...
8 building in building over a cupboard or drawer if the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. Building over a kitchen unit with door proper arrangements must be taken in des...
9 fo 0198 building over a kitchen unit with oven if the hob is built into a kitchen unit with an oven underneath, the recess must have the dimensions shown in diagrams 2 and 3, and should also incorporate suitable oven crosspiece supports to ensure an efficient cooling air circulation. Diagrams 4 an...
10 electrical connections any electrical work required to install this appliance should be carried out by a qualified electrician or competent person, in accordance with the current regulations. This appliance must be earthed. The manufacturer declines any liability should these safety measures not ...
11 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from min to max several ti...
