Zanussi TL1000 Instruction Manual - For The Installer
18
FOR THE INSTALLER
Technical Specifications
Dimensions
Height with panel
895 mm
Height without panel
850 mm
Width
397 mm
Depth
600 mm
Power supply voltage / frequency
230 V - 240 V / 50 Hz
Total power absorbed
2300 W - 2400 W / (10 A)
Heater rating
1950 W
Water pressure
minimum
5 N/cm² (0,5 kg/cm
2
)
maximum
80 N/cm² (8 kg/cm
2
)
Maximum load
Cotton
4,5 kg
Synthetics/delicates
2 kg
Wool
1 kg
Maximum spinning speed
1000 rpm
Electrical consumption (washing at 60°C)
1,2 kWh
This appliance complies with the following EC Directive :
- 72/23/EEC of 19.02.1973 - Low-Voltage Directive
- 89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.
Installation
Unpacking
Before installing the machine the packing and
transit bolts must be removed. Please retain the
packing and transit bolts for re-use in case the
machine is to be transported again.
Unpack the appliance. Tilt the appliance
backwards. Remove the polystyrene base, by
turning the appliance one quarter turn. (Fig. 1)
Open the lid and remove the polystyrene block
securing the drum. (Fig. 2)
Using a spanner remove the two transit bolts
(A) (Fig. 3)
The holes which are now visible must be filled
with the plugs (B) provided. (Fig. 4)
Retain the polystyrene block and transit bolts
for future use. (Fig. 5).
To enable the appliance to be pushed further
into the recess, the plastic crossbar holding the
hoses at the back of the appliance can be cut off
(Fig. 6).
Fig. 1
Fig. 2
Fig 4
B
A
Fig 3
Fig 5
Fig 6