- DL manuals
- Zanussi
- Washer
- TLE 1116 W
- Instruction Manual
Zanussi TLE 1116 W Instruction Manual
Summary of TLE 1116 W
Page 1
Instructions manual washing machine tle 1116 w 146 4959 01 - 0 7/06.
Page 2: Contents
2 contents for the user important safety information 3 your new washing machine 4 description of the appliance 5 detergent dispenser 5 the control panel 6-8 operating sequence 9-11 before use 9 load the laundry 9 measure out the detergent 9 add the fabric softener 9 switch the machine on 9 select th...
Page 3: Important Safety Information
3 important safety information it is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the ...
Page 4
4 your new washing machine your new washing machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Ecological hints to save water and energy and help protect the environment, we recommend that you follow these hints: adjust the quan...
Page 5: Description of The Appliance
5 description of the appliance detergent dispenser 1 detergent compartment for pre-wash . 2 detergent compartment for main wash . 3 fabric softener . 4 softener overflow lid handle for opening lid trap door for lint filter lever for castors 1 2 3 start/pause button programme phase indicator lights s...
Page 6: The Control Panel
6 the control panel 1 on/off button press this button to switch the washing machine on. Press the on/off button again to switch the machine off. 2 mains-on light this light is connected to the on/off button. It lights up when you press the button, and goes out when you press it again. 3 fabrics butt...
Page 7
7 rinse hold position: when you choose this option, the machine will not drain the water of the last rinse which could crease the laundry. At the end of the cycle, the light "end" will light to indicate that the water must be drained. To complete the cycle, choose one of the following options: • dra...
Page 8
8 to select rinse and spin , press the skip button once, the wash led goes out. To select spin only, press the skip button twice. The wash and rinse led's go out. To select drain , press the skip button three times, the wash - rinse - spin led's go out. If you wish to cancel or advance the running p...
Page 9: Operating Sequence
9 operating sequence before use before using your appliance for the first time, we recommend you to run a 90°c cotton cycle without any laundry, to remove any manufacture residue from the drum and tub: - pour 1/2 a measure of detergent into the "detergent dispenser" and start the machine. - select t...
Page 10
10 7 select the spin speed and the rinse hold option press the spin speed button repeatedly in order to select the desired spin speed or the rinse hold option. The relevant light will illuminate. If you select the rinse hold option, the machine will stop at the end of the programme with the water st...
Page 11
11 13 how to open the lid during the cycle of the programme you can open the lid after you have pressed pause, provided the following conditions exist: • the appliance is not in the heating phase, • the level of the water is not high, • the drum is not turning. If these requirements are met when you...
Page 12: Washing Hints
12 washing hints do not overload the machine. Weigh the laundry the first few times you use the appliance. The average weights of the most common items are listed below as a guide: 1000g=1kg sheet 700-1000 g pillow case 100-200 g tablecloth 400-500 g serviette 50-100 g tea towel 70-120 g linen hand ...
Page 13
13 which detergent? ... To ensure you obtain the best wash results from your appliance, it is important to use the right detergent in your everyday wash, and only detergents recommended for use in automatic machines. To maintain the appearance of your clothes and household textiles and to make them ...
Page 14: Wash Care Symbols
14 washing symbol wash action fabric normal (maximum) white cotton or linen without special finishes normal (maximum) cotton, linen or viscose without special finishes, colourfast at 60°c reduced (medium) nylon, polyester/cotton, viscose with special finishes, cotton/acrylic mix normal (maximum) cot...
Page 15: Washing Programmes
15 washing programmes programmes ( ) this programme at 60°c is the reference programme for the energy label according to eec directive 92/75. (*) the data is given purely as an indication: the consumption values may vary in relation to the quantity and type of laundry, the temperature of the water s...
Page 16: Washing Programmes
16 washing programmes special programmes (*) the data is given purely as an indication: the consumption values may vary in relation to the quantity and type of laundry, the temperature of the water supply and the ambient temperature. The data refers to the highest temperature provided for each progr...
Page 17: Maintenance and Cleaning
17 before carrying out any maintenance or cleaning you must disconnect the appliance from the electricity supply. Descaling the water we normally use contains lime. To help prevent the formation of lime deposits we recommend you periodically, particularly in hard water areas, use a water softening p...
Page 18
18 to drain the residual water : place a shallow container beneath the trap door. Turn the filter handle anticlockwise until the filter cap handle is vertical, any residual water will be released (fig.8). To clean the filter : unscrew the filter anticlockwise and remove (fig.9). Clean the filter car...
Page 19: Something Not Working
19 something not working certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local service force centre, please carry out the checks listed below. Important : if you call out an engineer to a fault l...
Page 20
20 symptom possible cause solution the machine vibrates or is noisy. The internal packing and/or transit bolts have not been removed. Remove internal packing/transit bolts. The wash load is unevenly distributed. See hints and tips section. The machine is overloaded. Observe the maximum loads quoted ...
Page 21: 08705 929929
21 in the event of your appliance requiring service, or if you wish to purchase spare parts, please con- tact your local service force centre by telephoning: 08705 929929 your telephone call will be automatically routed to the service force centre covering your post code area. For the address of you...
Page 22: Guarantee Conditions
22 guarantee conditions standard guarantee conditions we, zanussi-electrolux, undertake that if within 12 months of the date of the purchase this zanussi-electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option, repa...
Page 23: Installation Instructions
23 installation instructions it is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qual...
Page 24
24 fig. 1 fig. 2 fig 4 fig 6 fig 3 fig 5 unpacking packing used to protect internal parts of the washing machine during transport must be removed before the washing machine is used for the first time. Remove all packing from the washing machine. Tilt the washing machine sideways and then remove the ...
Page 25
25 levelling the appliance • the appliance must be levelled using the adjustable feet. • adjust the feet so that the appliance is level. The appliance must not rock when weight is applied. • check the appliance is level using a spirit level. Moving the appliance to move the washing machine, release ...
Page 26
26 water connection this appliance is designed to be permanently plumbed into your home's water supply and drai- nage system. Water inlet please install the water inlet hose onto the back of your washing machine : - insert the seal in the hole at the bottom of the back panel (fig. 1). - screw on the...
Page 27
27 electrical connection any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Warning: this appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. Before switching on, ma...
Page 28
© electrolux plc 2003.