Zanussi ZAF2 Instructions For Use Manual - 1. Instruction For The User

Manual is about: Hobs ZAF2

Summary of ZAF2

  • Page 1

    Mode d'emploi gebruiksaanwijzing bedienungsanweisungen instructions for use tables de cuisson kookplaten kochmulden hobs zaf 2.

  • Page 2: English

    30 • this appliance has been designed to be operated by adults and children under supervision. Young children must not be allowed to tamper with the controls or play near or with the oven. • this appliance has been designed for cooking edible foodstuff and to be used for domestic non- professional p...

  • Page 3: 1. Instruction For The User

    31 1. Instruction for the user hob burners control knobs the hob burners control knobs are situated on the hob front panel. The symbols on the knobs mean that : ● there is no gas supply there is maximum gas supply there is minimum gas supply lighting the burners • for easier lighting, proceed before...

  • Page 4: 3. Technical Data

    32 3. Technical data gas burners rating rapid burner (big) 3 kw (g20-g25) - 2,8 kw (g30-31) auxiliary burner (small) 1 kw category ii 2e+3+ setting natural gas 20 mbar / g25 25 mbar gas connection g 1/2" electric supply 230 v 50 hz hob recess dimensions length 270 mm. Width 490 mm. 2. Cleaning and m...

  • Page 5

    33 4. Instruction for the installer ● the side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. ● avoid installing the appliance in the proximity of inflammable materials (e.G. Curtains, tea towels etc.). ● the following instructions about i...

  • Page 6: 5. Electrical Connection

    34 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rati...

  • Page 7

    35 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 7), and replace them with the ones required for the type of gas in use (see table 2). • reassemble the parts, following the same procedu- re bac...

  • Page 8: 7.  Building In

    36 7. Building in a = auxiliary burner r = rapid burner these hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in fig. 9. Installation and assembly these hobs can be installed in a kitchen unit with an opening for insertion whose di...

  • Page 9

    37 possibilities for insertion kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in fig. 12. The panel fitted under the hob shou...