Summary of ZBA22421SA
Page 1
En zba22421sa user manual refrigerator.
Page 2: Safety Information
Contents safety information 2 safety instructions 3 operation 4 daily use 5 hints and tips 6 care and cleaning 7 troubleshooting 8 technical information 9 installation 10 subject to change without notice. Safety information before the installation and use of the appliance, carefully read the supplie...
Page 3: Safety Instructions
• do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. • do not damage the refrigerant circuit. • do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recomm...
Page 4: Operation
Use warning! Risk of injury, burns, electrical shock or fire. • do not change the specification of this appliance. • do not put electrical appliances (e.G. Ice cream makers) in the appliance unless they are stated applicable by the manufacturer. • be careful not to cause damage to the refrigerant ci...
Page 5: Daily Use
1. Turn the temperature regulator toward lower settings to obtain the minimum coldness. 2. Turn the temperature regulator toward higher settings to obtain the maximum coldness. Caution! If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temper...
Page 6: Hints and Tips
Hints and tips normal operating sounds the following sounds are normal during operation: • a faint gurgling and bubbling sound from coils sound when refrigerant is pumped. • a whirring and pulsating sound from the compressor when refrigerant is pumped. • a sudden cracking noise from inside appliance...
Page 7: Care and Cleaning
Care and cleaning warning! Refer to safety chapters. Periodic cleaning the equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and d...
Page 8: Troubleshooting
Ice that break away before defrosting is complete. 4. When defrosting is completed, dry the interior thoroughly. 5. Switch on the appliance. 6. Set the temperature regulator to obtain the maximum coldness and run the appliance for two or three hours using this setting. 7. Reload the previously remov...
Page 9: Technical Information
Problem possible cause solution water flows on the floor. The melting water outlet is not connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray. The temperature in the appliance is too low/too high. The temperature regulator is not set correc...
Page 10: Installation
Height mm 1225 width mm 560 depth mm 550 rising time hours 12 voltage volts 230 - 240 frequency hz 50 the technical information are situated in the rating plate, on the external or internal side of the appliance and in the energy label. Installation warning! Refer to safety chapters. Electrical conn...
Page 11
Www.Zanussi.Com 11.
Page 12: Www.Zanussi.Com/shop
Www.Zanussi.Com/shop 222370668-a-382014.