Zanussi ZBG 331 User Manual - The Oven Door and Its Gasket

33

The Oven Door and its gasket

Before cleaning the oven door, we recommend you to

remove it from the oven.

Proceed as follows:

1.

open the oven door completely;

2.

find the hinges linking the door to the oven (see

picture 1);

3.

unlock and turn the small levers located on the two

hinges (see  picture 2);

4.

handle the door by its left- and right-hand sides,

then slowly turn it towards the oven until it is half-

closed (see  picture 3);

5.

gently pull the oven door off its site (see  picture 3);

6.

place it on a steady plan;

Clean the oven door glass with warm soapy water and a

softh cloth only. Never use harsh abrasives.

Once the cleaning is carried out, refit the oven door,

following the procedure in reverse.

DO NOT 

clean the oven door while the glass

panels are warm. If this precaution is not observed

the glass panel may shatter.

If the door glass panel becomes chipped or has

deep scratches, the glass will be weakened and

must be replaced to prevent the possibility of the

panel shattering. Contact your local Service Centre

who will be pleased to advise further.

Models in stainless steel or aluminium:

We recommend to clean the oven door using only a wet

sponge and dry it up after cleaning with a soft cloth.

Never use steel wool, acids or abrasive products as they

can damage the oven surface.

Clean the oven control panel following the same

precautions.

The correct operation of the oven is ensured by a gasket

placed round the edge of the oven cavity.

• Periodically 

check

 the condition of this gasket. If

necessary, clean it without using abrasive cleaning

products.

• If the gasket shows to be 

damaged

, call you local

Service Centre. Do not use the oven until it has been

repaired.

1

2

3