Summary of ZDF21001NA
Page 1
Getting started? Easy. User manual zdf21001wa zdf21001xa zdf21001na en user manual dishwasher.
Page 2: Safety Information
Safety information before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. Children and vuln...
Page 3: Safety Instructions
• do not keep the appliance door open without supervision to prevent to fall on it. • before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. • do not use water spray and steam to clean the appliance. • the ventilation openings in the base (if applicable) mu...
Page 4
Disposal warning! Risk of injury or suffocation. • disconnect the appliance from the mains supply. • cut off the mains cable and discard it. • remove the door catch to prevent children and pets to get closed in the appliance. 4.
Page 5: Easy Start
Easy start 1 2 3 4 5 6 1 on/off indicator 2 programme marker 3 indicators 4 start button 5 delay button 6 programme knob indicators end indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. 5.
Page 6: Programmes
Programmes programme degree of soil type of load programme phases consumption values 1) duration (min) energy (kwh) water (l) 2) normal soil crockery and cutlery • prewash • wash 50 °c • rinses • dry 195 1.039 11 3) heavy soil crockery, cut- lery, pots and pans • prewash • wash 70 °c • rinses • dry ...
Page 7
Do not use detergent and do not load the baskets. The water hardness table german degrees (°dh) french degrees (°fh) mmol/l clarke degrees water softener level 47 -50 84 - 90 8.4 - 9.0 58 - 63 10 43 - 46 76 - 83 7.6 - 8.3 53 - 57 9 37 - 42 65 - 75 6.5 - 7.5 46 - 52 8 29 - 36 51 - 64 5.1 - 6.4 36 - 4...
Page 8: Daily Use
• release when delay and start to flash. • press . Indicators , delay and flash. The current setting is indicated by the intermittent flashing of the indicator : e.G. 5 intermittent flashes + pause + 5 intermittent flashes = level 5. • press to change the setting. Each time you press the button, the...
Page 9
Adding detergent 2 1 20 30 a b if the programme has a prewash phase, put a small quantity of detergent also in compartment b. Adding multi-tablets 2 1 20 30 programme selection mode the appliance must be in programme selection mode to start a programme. If the control panel does not show this condit...
Page 10
Starting a programme open the water tap, close the door, select a programme, press . Option delay with this option you can postpone the start of a programme of 3 hours. Set the programme, press delay. Press to start the countdown. At the end of the countdown, the programme starts. Opening the door w...
Page 11: Hints and Tips
At the end of the programme 5 min the indicator comes on. If you do not deactivate the appliance within 5 minutes all indicators goes off. This helps to decrease energy consumption. Turn the knob to . Close the tap. Hints and tips general the following hints will ensure optimal cleaning and drying r...
Page 12: Care and Cleaning
• if you use multi-tablets you can select the multitab option (if available). This option increases the cleaning and drying results with the use of multi-tablets. • detergent tablets do not fully dissolve with short programmes. To prevent detergent residues on the tableware, we recommend that you us...
Page 13: Troubleshooting
Cleaning the filters b a c • make sure that there are no residues of food or soil in or around the edge of the sump. • put back in place the flat filter (c). Make sure that it is correctly positioned under the 2 guides. • reassemble the filters (a) and (b). • put back the filter (a) in the flat filt...
Page 14
Problem and alarm code possible solution you cannot activate the appliance. • make sure that the mains plug is connected to the mains socket. • make sure that there is no a damage fuse in the fuse box. The programme does not start. • make sure that the appliance door is closed. • press start. • if t...
Page 15: Technical Information
Problem possible solution the dishes are wet. • the programme does not have a drying phase or has a drying phase with low temperature. • the rinse aid dispenser is empty. • the quality of the rinse aid can be the cause. Refer to "hints and tips" for other possible causes. Technical information dimen...
Page 16: Www.Zanussi.Com/shop
Www.Zanussi.Com/shop 100006930-a-472014.