Gr gas hob ≈ ”‘…¡ ¡ ≈ –…œ’ ГАЗОВАЯ ВАРОЧНАЯ ПАНЕЛЬ zdg 320 t œƒ« √ … ≈ ” ◊ –«”«” ¡… ≈√ ¡‘¡”‘¡”«” instruction booklet ru РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ gb.
2 • this appliance has been designed to be operated by adults and children under supervision. Young children must not be allowed to tamper with the controls or play near or with the oven. • this appliance has been designed for cooking edible foodstuff and to be used for domestic non-professional pur...
3 1. Instruction for the user hob burners control knobs the hob burners control knobs are situated on the hob front panel. The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply lighting the burners • for easier lighting, proceed before pu...
4 3. Technical data gas burners rating rapid burner (big) 3 kw (g20) - 2,8 kw (g30/31) auxiliary burner (small) 1 kw category ii 2h3+ setting natural gas g 20 - 20 mbar gas connection g 1/2" electric supply 230 v 50 hz hob recess dimensions length 270 mm. Width 490 mm. 2. Cleaning and maintenance • ...
5 4. Instruction for the installer the following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top....
6 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the ratin...
7 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 7), and replace them with the ones required for the type of gas in use (see table 2-2a ). • reassemble the parts, following the same procedure ba...
8 7. Building in installation and assembly these hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in fig. 9. Carry out the building in of the hob as follows: • put the relevant sealings, supplied with the hob, on the edges of the cut out, taking care t...
9 possibilities for insertion kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in fig. 11. The panel fitted under the hob shoul...
10
