Summary of ZDN11002XA
Page 1
Getting started? Easy. User manual zds22002wa en user manual.
Page 2: Safety Information
Safety information before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. General safety • ...
Page 3: Safety Instructions
Been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. • do not let children play with the appliance. • keep all detergents away from children. • keep children and pets away from the appliance door when it is open. • cleaning and user...
Page 4
Disposal warning! Risk of injury or suffocation. • disconnect the appliance from the mains supply. • cut off the mains cable and discard it. • remove the door catch to prevent children and pets to get closed in the appliance. 4.
Page 5: Easy Start
Easy start 1 2 3 4 5 6 1 on/off indicator 2 programme marker 3 indicators 4 start button 5 delay button 6 programme knob indicators end indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. Programmes programme d...
Page 6: Before First Use
Programme degree of soil type of load programme phases consumption values 1) duration (min) energy (kwh) water (l) normal soil crockery and cutlery • prewash • wash 65 °c • rinses • dry 100 - 110 1.2 - 1.6 15 - 16 heavy soil crockery, cutlery, pots and pans • prewash • wash 70 °c • rinses • dry 130 ...
Page 7
The water hardness table german degrees (°dh) french degrees (°fh) mmol/l clarke degrees water softener level 47 -50 84 - 90 8.4 - 9.0 58 - 63 10 43 - 46 76 - 83 7.6 - 8.3 53 - 57 9 37 - 42 65 - 75 6.5 - 7.5 46 - 52 8 29 - 36 51 - 64 5.1 - 6.4 36 - 45 7 23 - 28 40 - 50 4.0 - 5.0 28 - 35 6 19 - 22 33...
Page 8: Daily Use
• press . Indicators , delay and flash. The current setting is indicated by the intermittent flashing of the indicator : e.G. 5 intermittent flashes + pause + 5 intermittent flashes = level 5. • press to change the setting. Each time you press the button, the level increases. After level 10 you will...
Page 9
Adding detergent 2 1 20 30 a b if the programme has a prewash phase, put a small quantity of detergent also in compartment b. Adding multi-tablets 2 1 20 30 • do not fill the salt container and the rinse aid dispenser. • adjust the water softener to the lowest level. • set the rinse aid dispenser to...
Page 10
Starting a programme open the water tap, close the door, select a programme, press . Option delay with this option you can postpone the start of a programme of 3 hours. Set the programme, press delay. Press to start the countdown. At the end of the countdown, the programme starts. Opening the door w...
Page 11: Hints and Tips
At the end of the programme 5 min the indicator comes on. If you do not deactivate the appliance within 5 minutes all indicators goes off. This helps to decrease energy consumption. Turn the knob to . Close the tap. Hints and tips general the following hints will ensure optimal cleaning and drying r...
Page 12: Care and Cleaning
• do not use more than the correct quantity of detergent. Refer to the instructions on the detergent packaging. What to do if you want to stop using multi-tablets before you start to use separately detergent, salt and rinse aid do the following procedure. 1. Set the highest level of the water soften...
Page 13: Troubleshooting
C • make sure that there are no residues of food or soil in or around the edge of the sump. • put back in place the flat filter (c). Make sure that it is correctly positioned under the 2 guides. • reassemble the filters (a) and (b). • put back the filter (a) in the flat filter (c). Turn it clockwise...
Page 14: Technical Information
Problem and alarm code possible solution the appliance does not fill with wa- ter. • the indicator flashes 1 time intermittently. • the indicator flashes continu- ously. • make sure that the water tap is open. • make sure that the pressure of the water supply is not too low. For this information, co...
Page 15: Environmental Concerns
Electrical connection 1) voltage (v) 220-240 frequency (hz) 50 water supply pressure min. / max. Bar (mpa) 0.5 (0.05) / 8 (0.8) water supply cold water or hot water 2) max 60 °c capacity place settings 9 power consumption left-on mode (w) 0.50 power consumption off-mode (w) 0.50 1) refer to the rati...
Page 16: Www.Zanussi.Com/shop
Www.Zanussi.Com/shop 156975660-b-072014.