Zanussi ZDS 6070 Instruction Booklet - Operating Sequence
35
1.
Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2.
Check that there is rinse aid
and salt
3.
Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
4.
Ensure that the spray arms can
rotate freely.
5.
Measure out detergent
Add the required amount of detergent into the
dispenser according to the dosage instructions
from the manufacturer of your brand.
Close the detergent dispenser lid.
6.
Close the dishwasher door
7.
Set the programme
Turn the programme selector dial clockwise until
the letter of the programme you wish to select
corresponds with the programme marker on the
control panel.
If necessary select the temperature of the main
wash according to the instructions in the
"Washing programmes" chart (see "Required
push buttons").
8.
Start the programme
Depress the On/Off push button.
The On/Off indicator light will come on and
the machine will start.
If you wish to interrupt the washing
programme at any time press this button
again.
9.
At the end of the washing
programme
At the end of the programme the
dishwasher will automatically stop.
The On/Off indicator light remains on until
the On/Off push button is depressed.
10. Switch off the dishwasher
Switch off the dishwasher by pressing the
On/Off push button and open the door.
Wait a few minutes before removing the
dishes; in this way they will be cooler and
the drying will be improved.
Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in the
lower one.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working; if the
door is opened however, a safety device
ensures that the machine stops.
Important!
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished, as
steam may escape.
SEQ12en