Zanussi ZDT 312 User Manual - Setting The Water Softener
Water hardness
Adjusting the water hardness
setting
Use of salt
Clarke
°TH
mmol/l
manually
electronically
5 - 12
7 - 18
0,7 - 1,8
1
level 2
yes
< 5
< 7
< 0,7
1
level 1
no
The water softener must be set in both ways:
manually, using the water hardness dial and
electronically.
Setting the water softener manually (see table)
Set switch to position 1 or
2
The water softener is factory set at position 2.
Setting the water softener
electronically (see table)
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C until the lights of the func-
tion buttons A, B and C start flashing.
3. Press function button A, the lights function
buttons B and C turn off while the light of
function button A goes flashing, at the
same time the end of programme indica-
tor light starts to flash, along with a se-
quence of intermittent audible signals. The
current level is indicated by the number of
flashes of the end of programme indicator
light with a sequence of intermittent audible
signals and a pause of a few seconds.
Examples:
5 flashes / 5 intermittent audible signals,
pause,
5 flashes / 5 intermittent audible signals,
pause, etc...= level 5
6 flashes / 6 intermittent audible signals,
pause,
6 flashes / 6 intermittent audible signals,
pause, etc...= level 6
4. To change the level press the function but-
ton A. Each time button is pressed the level
changes (For the selection of a new level
see the chart).
Examples:
10