- DL manuals
- Zanussi
- Dishwasher
- ZDT 312
- User Manual
Zanussi ZDT 312 User Manual - Filling With Rinse Aid
Remove any trace of salt. Replace the cap tightly
turning it clockwise until it
stops with a click.
IMPORTANT!
Immediately start a complete programme.
IMPORTANT!
Water will overflow from the container as salt is added.
IMPORTANT!
Top up the special salt when the light on the
control panel illuminates.
Filling with rinse aid
Open the lid.
Fill up with rinse aid. The
maximum level for filling is
indicated by "max"
Clean up any rinse aid
which overflows. Close
the lid and press until it
locks.
CAUTION!
Never fill the rinse aid dispenser with any other sub-
stances (e.g. dishwasher cleaning agent, liquid deter-
gent). This would damage the appliance.
IMPORTANT!
Top up the rinse aid when the light on the control panel
illuminates.
12
Summary of ZDT 312
Page 1
User manual dishwasher zdt 312.
Page 2: Appliance
Thank you for selecting our appliance we wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user ...
Page 3: Safety Information
Safety information in the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, in- cluding its hints and warnings. To avoid unnecessary mistakes and accidents, it is im- portant to ensure that all people using the ap...
Page 4: Installation
Installation • check your dishwasher for any transport damage. Never connect a damaged ma- chine. If your dishwasher is damaged con- tact your supplier. • all packaging must be removed before use. • any electrical and plumbing work required to install this appliance must be carried out by a qualifie...
Page 5
In addition to the dishwashing programme se- lection, the following functions can also be set with the help of these buttons: • the setting of the water softener, • deactivation/activation of the audible sig- nals. • cancel a washing programme or a delay start in progress • activation/deactivation o...
Page 6: Audible Signals
Audible signals audible signals have been introduced to help indicate which operations the dishwasher is performing: • setting the water softener, • end of the programme, • intervention of an alarm due to malfunction. Important! Factory setting: audible signals activated. Deactivation/activation of ...
Page 7
4. The opening of the door will interrupt the countdown. Close the door; the countdown will continue from the point at which it was interrupted. 5. Once the delay start has elapsed the pro- gramme will start automatically. Cancelling the delay start to cancel a delay start in progress you have to re...
Page 8: Washing Programmes
Washing programmes programme degree of soil type of load programme description intensive 70° heavy soil crockery, cutlery, pots and pans prewash main wash 2 intermediate rinses final rinse drying normal 65° normal soil crockery, cutlery, pots and pans prewash main wash 1 intermediate rinses final ri...
Page 9: When Using Tablets That
When using tablets that integrate rinse aid and detergent: there is no need to fill up with rinse aid – set the water softener – add special (dishwasher) salt when using tablets that integrate rinse aid, detergent, salt function and other additives: there is no need to fill up with special salt or r...
Page 10: Setting The Water Softener
Water hardness adjusting the water hardness setting use of salt clarke °th mmol/l manually electronically 46 - 52 65 - 75 6,5 - 7,5 2 level 8 yes 36 - 45 51 - 64 5,1 - 6,4 2 level 7 yes 28 - 35 40 - 50 4,0 - 5,0 2 level 6 yes 23 - 27 33 - 39 3,3 - 3,9 2 level 5 yes 18 - 22 26 - 32 2,6 - 3,2 1 level ...
Page 11: Filling With Dishwasher Salt
Light with a sequence of intermittent audible signals and a pause of a few seconds. Examples: 5 flashes / 5 intermittent audible signals, pause, 5 flashes / 5 intermittent audible signals, pause, etc...= level 5 6 flashes / 6 intermittent audible signals, pause, 6 flashes / 6 intermittent audible si...
Page 12: Filling With Rinse Aid
Remove any trace of salt. Replace the cap tightly turning it clockwise until it stops with a click. Important! Immediately start a complete programme. Important! Water will overflow from the container as salt is added. Important! Top up the special salt when the light on the control panel illuminate...
Page 13: Loading Cutlery and Dishes
Adjusting the dosage of rinse aid increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce the dose if there are whitish streaks on the dishes or a bluish film on glassware or knife blades. Open the lid. Set the dosage level. (the dose is factory set in po- sit...
Page 14
For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • cutlery with wooden, horn, china or mother-of- pearls handles. • plastic items that are not heat resistant. • older cutlery with glued parts that are not tempera- ture resistant. • bonded c...
Page 15: Adjusting The Height of The
Load upper basket. Light items (plastic bowls etc.) must be loaded in the up- per basket and arranged so they do not move. For taller items, the cup racks can be folded up- wards. If plates are to be loaded in the upper basket: load them starting from the rear positions; tilting them slightly forwar...
Page 16: Use of Detergent
Important! Never lift or lower the basket on one side only important! When the basket is in the higher position you will not be able to use the cup racks. Use of detergent important! Only use detergents suitable for dishwashers. Observe the manufacturer’s dosing and stor- age recommendations. Open t...
Page 17: Unloading The Dishwasher
Unloading the dishwasher • hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appli- ance. • empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. • wat...
Page 18: Cleaning The Spray Arms
Put the flat filter a back in the base of the washing compartment and ensure that it fits perfectly under the two guidesd. Replace the filters and lock by turning the handle clockwise to the stop. Cleaning the spray arms never try to remove the spray arms. If residues of soil have clogged the holes ...
Page 19: Environmental Concerns
3. Remove the water inlet and discharge ho- ses. 4. Pull the machine out together with the ho- ses. Avoid over tilting the machine during transpor- tation. Environmental concerns packaging material the packaging materials are environmentally friendly and can be recycled. The plastic com- ponents are...
Page 20
Fault code and malfunction possible cause and solution • 1 intermittent audible signal • continuous flashing of the light of the running programme • 1 flash of the "end of programme " indicator light the dishwasher does not fill with water. • the water tap is blocked or furred with limescale. Clean ...
Page 21: Consumption Values
The wash results are not satisfactory the dishes are not clean • the wrong washing programme has been selected. • the dishes are arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. • the spray arms do not rotate freely due to incorrect arran...
Page 22: Technical Data
Temperature of the water and also by the var- iations of the power supply and the amount of dishes. Consumption values programme programme duration (in minutes) energy consumption (in kwh) water (litres) intensive 70° 80-90 1,6-1,8 22-24 normal 65° 95-105 1,4-1,6 18-20 60°a30' 30 0,9 9 bio 50° (test...
Page 23: Installation
Full load: 12 standard place settings amount of detergent required 5 g + 25 g (type b) rinse aid setting position 4 (type iii) upper basket cutlery basket lower basket cup racks: position a installation warning! Any electrical and/or plumbing work required to install this appliance should be carried...
Page 24: Inlet Hose
Inlet hose connect the inlet hose to a water tap with an external thread of 3/4”. The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks. Drain hose connect drain hose to the sink. Requi...
Page 25: Electrical Connection
Electrical connection caution! Safety standards require the appliance to be earthed. Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. The fuse rating is also to be fo...
Page 26
26.
Page 27
27.
Page 28
Www.Electrolux.Com www.Zanussi-electrolux.Co.Uk 156991180-00-26112007.