Zanussi ZEV6642FBV User Manual - Installation Instructions
Problem
Possible cause
Remedy
There is water or fat stains on the
control panel.
Clean the control panel.
An acoustic signal sounds and
the appliance deactivates.
An acoustic signal sounds when
the appliance is deactivated.
You put something on one or
more sensor fields.
Remove the object from the sensor
fields.
The appliance deactivates.
You put something on the sensor
field
.
Remove the object from the sensor
field.
The residual heat indicator does
not come on.
The cooking zone is not hot be-
cause it operated only for a short
time.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
The Automatic Heat Up function
does not operate.
The cooking zone is hot.
Let the cooking zone become suffi-
ciently cool.
The highest heat setting is set.
The highest heat setting has the
same power as the Automatic Heat
Up function.
You decreased the heat setting
from
.
Start from
and only increase the
heat setting.
You cannot activate the outer
ring.
Activate the inner ring first.
The sensor fields become hot.
The cookware is too large or you
put it too near to the controls.
Put large cookware on the rear
cooking zones if necessary.
comes on.
The Automatic Switch Off oper-
ates.
Deactivate the appliance and acti-
vate it again.
comes on.
The Child Safety Device or the
Lock function operates.
Refer to the chapter “Daily use”.
and a number come on.
There is an error in the appliance.
Disconnect the appliance from the
electrical supply for some time.
Disconnect the fuse from the elec-
trical system of the house. Connect
it again. If
comes on again,
speak to the service centre.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ce-
ramic (it is in the corner of the glass surface)
and an error message that comes on.
Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instruc-
tions about the customer service and condi-
tions of guarantee are in the guarantee booklet.
Installation instructions
Warning! Refer to "Safety information"
chapter.
Before the installation
Before the installation of the appliance, record
the information below from the rating plate. The
10
www.zanussi.com