Zanussi ZEV6646XBA User Manual - page 7
Residual heat indicator
Warning! The risk of burns from residual heat!
Operating instructions
Activation and deactivation
Touch for 1 second to activate or deactivate the appli-
ance.
Automatic Switch Off
The function deactivates the appliance automatically if:
• All cooking zones are deactivated .
• You do not set the heat setting after you activate the
appliance.
• You spill something or put something on the control
panel for more than 10 seconds, (a pan, a cloth, etc.).
The sound operates some time and the appliance deac-
tivates. Remove the object or clean the control panel.
• You do not deactivate a cooking zone or change the
heat setting. After some time comes on and the ap-
pliance deactivates. See the table.
The times of Automatic Switch Off
Heat setting
, -
-
-
The cooking zone de-
activates after
6 hours
5 hours
4 hours
1.5 hours
The heat setting
Touch to increase the heat setting. Touch to de-
crease the heat setting. The display shows the heat set-
ting. Touch and at the same time to deactivate the
cooking zone.
Activation and deactivation of the outer rings
You can adjust the surface you cook to the dimension of
the cookware.
To activate the outer ring touch the sensor field /
. The indicator comes on. For more outer rings touch the
same sensor field again. The subsequent indicator comes
on.
Do the procedure again to deactivate the outer ring. The
indicator goes out.
Automatic Heat Up
You can get a necessary heat setting in a shorter time if
you activate the Automatic Heat Up function. This function
sets the highest heat setting for some time (see the illus-
tration), and then decreases to the necessary heat setting.
To start the Automatic Heat Up function the cooking zone
must be cold (no in the display). Touch of the
cooking zone again and again until the necessary heat set-
1
2
3
4
5
6
7
8
9
10
11
0
1
2
3
4
5
6
7
8
9
7