Zanussi ZFT10210WA User Manual - page 9
Problem
Possible cause
Solution
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before stor-
ing.
The door is not closed correct-
ly.
Refer to "Closing the door".
The FastFreeze function is
switched on.
Refer to "FastFreeze function".
There is too much frost and
ice.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
Refer to "Closing the door".
The water drainage plug is not
correctly positioned.
Position the water drainage
plug in the correct way.
Food products are not wrap-
ped properly.
Wrap the food products better.
Temperature is set incorrectly.
Refer to "Operation" chapter.
The compressor does not start
immediately after pressing the
FastFreeze, or after changing
the temperature.
This is normal, no error has oc-
curred.
The compressor starts after a
period of time.
Temperature cannot be set.
The FastFreeze function is
switched on.
Switch off FastFreeze manual-
ly, or wait until the function re-
sets automatically to set the
temperature. Refer to "Fast-
Freeze function"
Door is misaligned or interferes
with ventilation grill.
The appliance is not levelled.
Refer to "Levelling".
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed correct-
ly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are stored
at the same time.
Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened of-
ten.
Open the door only if necessa-
ry.
The FastFreeze function is
switched on.
Refer to "FastFreeze function".
9