Zanussi ZFT10210WA User Manual - Technical Data
Problem
Possible cause
Solution
It is too cold inside the
freezer
Temperature regulator may be set
incorrectly
Set a warmer temperature
The appliance does not
work at all. Neither cooling
nor lighting works
Plug is not connected to the mains
socket properly
Connect the mains plug properly
Power does not reach the appli-
ance
Try connecting another electrical de-
vice to the power outlet
The appliance is not switched on
Switch on the appliance
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Call an electrician
The appliance does not
cool at all
Plug is not connected to the mains
socket properly
Connect the mains plug properly
There is no voltage in the mains
socket (try to connect another ap-
pliance into it)
Call an electrician
The appliance is not switched on
Switch on the appliance
Temperature Regulator is not on
Check the Temperature Regulator
Green indicator flashing
Temperature sensor problem
Call the service personnel
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "In-
stallation".
3.
If necessary, replace the defective door
gaskets. Contact the Service Center.
Technical data
Dimension
Height
850 mm
Width
595 mm
Depth
635 mm
Rising Time
13 h
Voltage
230 V
Frequency
50 Hz
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
9
www.zanussi.com