Summary of ZFT710W
Page 1
En user manual freezer zft710w zft710x.
Page 2: Contents
Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ 6 care and cleaning _ _ _ _ _ _ _ _ _ _ _ _...
Page 3
To the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (pow- er cord, plug, compressor) must be re- placed by a certified service agent or qualified service personnel to avoid hazard. 1. Power cord must not be lengthened. 2. Make sure that the power plug...
Page 4: Control Panel
• wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condens- er) to prevent possible burn. • the appliance must not be located close to radiators or cookers. • make sure that the mains plug is accessible after the installation of...
Page 5: First Use
Placing food inside the cabinet, but the light should go out again when the temper- ature returns to the correct storage level. 7. When the appliance has reached the set temperature (the red indicator light has gone out) press the freezer switch again to switch off the fast freeze function. The yell...
Page 6: Helpful Hints And Tips
The freezing process lasts 24 hours: during this period do not add other food to be frozen. Storage of frozen food when first starting-up or after a period out of use, before putting the products in the com- partment let the appliance run at least 2 hours on the higher settings. Important! In the ev...
Page 7
Ing must therefore only be carried out by au- thorized technicians. Periodic cleaning the equipment has to be cleaned regularly: • clean the inside and accessories with luke- warm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debr...
Page 8: What to Do If…
1. Disconnect the appliance from electricity supply 2. Remove all food 3. Defrost and clean the appliance and all ac- cessories 4. Leave the door/doors open to prevent un- pleasant smells. Important! If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside ...
Page 9: Technical Data
Problem possible cause solution large quantities of food to be fro- zen were put in at the same time insert smaller quantities of food to be frozen at any one time. Food placed in the appliance was too warm allow food to cool to room tempera- ture before storing. Products to be frozen are placed too...
Page 10: Installation
Installation caution! Read the "safety information" carefully for your safety and correct operation of the appliance before installing the appliance. Positioning this appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for optimum performance install this applian...
Page 11
1. Remove the plug from the power sock- et. 2. Tilt back the appli- ance carefully so that the compressor can- not touch the floor. 3. Unscrew the left foot. 4. Remove the lower door hinge by un- screwing the 2 retain- ing screws. 5. Remove the hinge pin from the bottom of the door. 6. Slot the hing...
Page 12: Environmental Concerns
C brown: live d blue: neutral as the colours of the wires in the mains lead of this appliance may not correspond with the col- oured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yel- low to the terminal marked either with the letter “e“ ...
Page 13
13 www.Zanussi.Com.
Page 14
14 www.Zanussi.Com.
Page 15
15 www.Zanussi.Com.
Page 16
Www.Zanussi.Com/shop 200 384357-a-012 012.