Zanussi ZFU23400WA User Manual

Summary of ZFU23400WA

  • Page 1

    En user manual freezer zfu23400wa.

  • Page 2: Contents

    Contents safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 product description _ _ _ _ _ _ _ _ _ _ _ _ _ 4 control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 helpful hints and tips _ _ _ _ _ _ _ _ _ ...

  • Page 3

    During transportation and installation of the appliance, be certain that none of the com- ponents of the refrigerant circuit become damaged. If the refrigerant circuit should become dam- aged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situa...

  • Page 4: Product Description

    • it is advisable to wait at least four hours be- fore connecting the appliance to allow the oil to flow back in the compressor. • adequate air circulation should be around the appliance, lacking this leads to overheat- ing. To achieve sufficient ventilation follow the instructions relevant to insta...

  • Page 5: Control Panel

    3 freezer baskets 4 rating plate 5 maxibox baskets control panel 1 2 3 4 5 1 alarm light 2 fast freeze indicator 3 fast freeze switch 4 pilot light 5 temperature regulator switching on insert the plug into the wall socket. Turn the temperature regulator clockwise to a medium setting. The pilot light...

  • Page 6: First Use

    Freezing fresh food the freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh food activate the fast freezing function at least 24 hours before placing the food to be frozen in the freezer compartment. Place the fresh food to...

  • Page 7: Care And Cleaning

    Er settings to allow automatic defrosting and so a saving in electricity consumption. Hints for freezing to help you make the most of the freezing process, here are some important hints: • the maximum quantity of food which can be frozen in 24 hrs. Is shown on the rating plate; • the freezing proces...

  • Page 8: Troubleshooting

    Defrosting the freezer a certain amount of frost will always form on the freezer shelves and around the top com- partment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. To remove the frost, follow the instructions be- low: • switch off the appliance and pull out the p...

  • Page 9: Technical Data

    Problem possible cause solution the compressor operates continually. The temperature is not set correct- ly. Set a higher temperature. The door is not closed correctly. Refer to "closing the door". The door has been opened too fre- quently. Do not keep the door open longer than necessary. The produc...

  • Page 10

    Positioning this appliance can be installed in a dry, well ventilated indoor, also in a garage or cellar, but for optimum performance install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: climate class ambi...

  • Page 11

    Warning! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. A b c d e important! The wires in the mains lead are coloured in accordance with the following code: a green and yellow: earth c brown: live d blue: neutral as the colours o...

  • Page 12: Environmental Concerns

    1. Remove the plinth. 2. Unscrew and re- move the lower hing- es. 3. Remove the door. 2 1 4. Unscrew the upper pin and screw it on the opposite side. 5. Refit the door. 6. Make sure the edge of the door is parallel with the edge of the top. A b 7. Unscrew the pin (a) and screw it on the opposite sid...

  • Page 13

    13 www.Zanussi.Com.

  • Page 14

    14 www.Zanussi.Com.

  • Page 15

    15 www.Zanussi.Com.

  • Page 16

    Www.Zanussi.Com/shop 280 151019-a-492 012.