Zanussi ZFV805 User Manual

Summary of ZFV805

  • Page 1

    Washing machine user manual zwf185w.

  • Page 2

    The contents section 1:before using • safety warnings • recommendations section 2:installation • removal of transportation screws • adjustment of feet • electrical connection • water supply connection • water drain connection section 3:technical specifications section 4:control panel • start/pause b...

  • Page 3

    Section 1:before using safety warnings •••• do not use a multiple socket or extension cord. • do not insert a plug with damaged or broken cord into the socket. • if the cord is damaged it should be replaced by the manufacturer or appointed service agent in order to avoid a hazard. •••• never remove ...

  • Page 4

    •••• if you will not use your machine for a long time, unplug your machine, close the water supply and leave the door open in order to keep the inside of the machine dry and for prevention from unpleasant odour. •••• as a result of the quality control procedures, a certain amount of water may remain...

  • Page 5

    •••• you can adjust the balance of your machine from its feet. •••• first, loosen the plastic adjustment nut. •••• adjust by rotating the feet upwards or downwards. •••• after the balance has been reached, tighten the plastic adjustment nut again by rotating it upwards. •••• never put cartons, woode...

  • Page 6

    • water pressure of 1-10 bars from your tap will enable your machine to work more efficiently.(1 bar pressure means water flow of more than 8 liters in 1 minute from a fully opened tap). • after connections are completed, check for the non-leakage of the connection joints by turning on your tap comp...

  • Page 7

    Section 3:technical specifications zwf185w maximum dry laundry capacity (kg) 5 recommended loading (kg) 4,5 height (cm) 85 width (cm) 59,6 depth (cm) 51 maximum spin cycle ( rpm ) 800 (*) maximum spin cycles depend on the model you’ve chosen 1 2 3 4 5 6 7 1-upper tray 5-handle 2-detergent drawer 6-f...

  • Page 8

    Section 4:control panel 1 2 3 4 5 6 7 8 1-detergent drawer 5-program knob 2-start/pause light 6-start/pause button 3-function indicator lights 7-function buttons 4-program ready light 8-program end light 7.

  • Page 9

    Start/pause button used to start a selected program or pause during running. Warning! It is required for the program knob to be brought to o(off) position before selecting the program or changing a continuing program. Function indicator lights when the start/pause button or any function button is pr...

  • Page 10

    If you do not want your sensitive clothes to be spinned or you want them to be spinned sensitively, turn the program knob to o (off) position. Bring the program knob on one of the draining or spinning programs you desire and press the start/pause button. If the program you have selected is a drain p...

  • Page 11

    Warning! Functions vary depending on the model you have chosen.If you forgot to use additional function and your machine starts to wash push the additional function button if the indicator light is on. Additional function will be activated.If the indicator light is not on,additional function will no...

  • Page 12

    O stop 1 cotton 90˚ 2 cotton 60˚(prewash) 3 cotton 60˚ 4 cotton 40˚ 5 eco wash 6 cotton 30˚ 7 quick wash 8 cotton cold 9 mix wash 10 synthetic 60˚ 11 baby wash 12 synthetic 40˚ 13 sport clothes 14 synthetic cold 15 curtain wash 16 delicate 30˚ 17 delicate cold 21 rinsing 18 hand wash 19 wool 30˚ 22 ...

  • Page 13

    • pull the textiles like trousers,knitted fabric,t-shirt and sweat shirt inside out. • wash your small clothes like socks and handkerchiefs in a washing bag. Wash up tol 90 ˚c wash up to 60 ˚c wash up to 30 ˚c not washable in washing machine placement of the clothes into the machine • open the door ...

  • Page 14

    • you can use fluid detergents in all programs without pre-washing. For this, mount the fluid detergent level plate in the second compartment of the detergent drawer and arrange the amount of fluid detergent according to the levels on this plate. Running the machine program selection and features se...

  • Page 15

    • the door will be unlocked in approximately two minutes after the program ends.You can open the door by pulling the handle of the door towards yourself and take out your clothes. • after you unload your clothes leave the door open to dry the interior of your machine. • unplug your machine. • close ...

  • Page 16

    Max dry load capacity (kg) program detergent compart. Additional function button zwf185w type of laundry explanations 1-cotton 90˚ 2 5 dirty, boil, cotton and linen textile 2-cotton 60˚ (prewash) 1+2 5 very dirty, cotton, coloured and linen textile 3-cotton 60˚ 2 5 dirty, cotton, coloured and linen ...

  • Page 17

    Max dry load capacity (kg) program detergent compart. Additional function button zwf185w type of laundry explanations 13-sport clothes 2 3 sport clothes all sport clothes and jeans 14-synthetic cold 2 3 slightly dirty, synthetic or synthetic mixture sensitive laundry.Washed without heating the tap w...

  • Page 18

    • remove the water inlet hose. • remove the filters found on the water inlet valves by using a pincer and wash thoroughly with a brush. • clean the filters of the water inlet hoses located on the tap side by removing manually together with the seal. • after you clean the filters, you can fit them th...

  • Page 19

    Warning! Danger of being scalded! Since the water inside the pump maybe hot, wait for it to cool. Detergent drawer detergents may form a sediment in your detergent drawer or in housing of the detergent drawer in time. To clean the sediment, pull out the detergent drawer from time to time.To pull out...

  • Page 20

    Siphon plug pull out the detrgent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly. The cabinet clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning subst...

  • Page 21

    Section 7:practical information alcoholic beverages: the stain point, should first be washed with cold water, than should be wiped with glycerine and water and be rinsed with water mixed with vinegar. Shoe polish: the stain should be slightly scratched without ruining the cloth, rubbed with detergen...

  • Page 22

    Mould: mould stains should be cleaned as soon as possible. The stain should be washed with detergent, and if it does not disappear, it should be wiped with oxygenated water (in proportion of 3%). Ink: hold the stained area under cold water and wait until the inky water completely runs off. Then rub ...

  • Page 23

    Failure probable cause methods of elimination it is unplugged. Insert the plug into the socket. Your fuse is defected. Change your fuse. The electric power is off. Check the electric power. Start/pause button has not been pressed. Press the start/pause button. The program knob is in o(off) status. B...

  • Page 24

    Failure probable cause methods of elimination there is a small amount of clothes in the device. It does not prevent operation of the machine. Excessive amount of clothes are filled in the machine or the clothes are not placed in a well-balanced manner. Do not exceed the recommended quantity of cloth...

  • Page 25

    Failure probable cause methods of elimination clothes exceeding the maximum capacity has been filled in your machine. Put the clothes in your machine in a manner not to exceed its maximum capacity. Your water may be hard. Use the amount of detergent according to the declaration of the detergent prod...

  • Page 26

    Failure probable cause methods of elimination the spining process is not done or starts with delay . No failure. The unbalanced load control may works in that way. The unbalanced load control system will try to distribute your clothes in a homogenous manner. After your clothes are distributed, passa...

  • Page 27

    Failure code failure indicator probable failure the process to be done err 02 the program ready light blinks. The water level in your machine is below heater. The pressure of your water supply may be low or locking. Turn on the tap to the end.Water may be cut, check it.If the problem is still contin...

  • Page 28

    Failure code failure indicator probable failure the process to be done err 05 the start/pause light and program end light blink. The heater of your machine or the heat sensor has failed. Shut down your machine and unplug. Turn off your tap and apply to the nearest authorized service. Err 06 the prog...

  • Page 29

    Section 10: international washing signs washing temparature. Do not wash (hand wash) lukewarm iron. Medium hot iron. Hot iron. Do not iron. Do not tumble dry. Hang to dry. Drip dry. Dry flat. Do not bleach. Handy to bleach. All of these are dry cleaning symbols. The letters are to instruct the clean...