Summary of ZGF 6420
Page 1
Gas hob zgf 6420 instruction booklet please read this instruction booklet before using the appliance gb.
Page 2: Important Safety Information
2 important safety information you must read these warnings carefully before installing or using the hob. If you need assistance, contact our customer care department on 08705 727727 installation ! This appliance must be installed and serviced by a competent person as stated in the gas safety (insta...
Page 3: Description of The Hob
3 1. Hob top 2. Auxiliary burner 3. Semi-rapid burners 4. Rapid burner 5. Control knobs description of the hob for the user contents for the installer important safety information 2 description of the hob 3 operation 4 maintenance and cleaning 4 something not working? 5 service and spare parts 6 cus...
Page 4: Maintenance and Cleaning
4 maintenance and cleaning a - burner cap b - burner crown c - ignition electrode fig. 1 hob burners to light a burner: ! Push in the relevant control knob and turn it anticlockwise to maximum position; ! Then adjust the flame as required. If the burner does not ignite, turn the control knob to zero...
Page 5: Cast Iron Pan Supports
5 cast iron pan supports the hob has cast iron pan supports. Take care when removing them. They are very heavy and could damage the hob or your kitchen furniture if you let them fall down. To keep the pan supports in the correct position, they are hooked into hinges at the back of the hob. When remo...
Page 6: Zanussi Guarantee Conditions
6 customer care department for general enquiries concerning your zanussi appliance or for further information on zanussi products, please contact our customer care department by letter or telephone at the address below or visit our website at www.Zanussi.Co.Uk customer care department zanussi major ...
Page 7: European Guarantee
7 european guarantee this appliance is guaranteed by electrolux in each of the countries listed below for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move with you s...
Page 8: Engineers Technical Data
8 rear left burner (semi rapid) heat input 2.0 kw (6824 btu/hr) front left burner (auxiliary) heat input 1.0 kw (3412 btu/hr) rear right burner (semi rapid) heat input 2.0 kw (6824 btu/hr) front right burner (rapid) heat input 3.0 kw (10236 btu/hr) instructions for the installer engineers technical ...
Page 9: Provision For Ventilation
9 important safety requirements 650 mm 400 mm 400 mm 100 mm 50 mm 50 mm 55 mm 600 mm 700 mm 400 mm 100 mm 400 mm 50 mm 55 mm 50 mm i clearances required when fitting the hob without a cooker hood above clearances required when fitting the hob with a cooker hood above fo 0813 fo 0812 700 mm this hob ...
Page 10: Gas Connection
10 rectangular cut-out size for hob a) end of shaft with nut b) washer c) elbow fo 0814 gas connection connection to the gas supply should be with either rigid or semi-rigid pipe, i.E. Steel or copper. The connection should be suitable for connecting to rc 1/2 (1/2 bsp male thread). When the final c...
Page 11: Building In
11 on/off switch flex outlet on/off switch flex outlet fo 0763 fo 2564 fo 2044 1 2 3 fo 0199 a fitting the hob into the worktop " carry out the building in of the hob as follows: • put the seals supplied with the hob, on the edges of the cut out: place them along the side edges and at 8 mm from the ...
Page 12: Electrical Connections
12 electrical connections any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. This hob must be earthed. The manufacturer declines any liability should these safety measures not be observed....
Page 13: Fault Finding
13 fault finding preliminary electrical systems check a. Earth continuity check - appliance must be electrically disconnected - meter set on Ω (ohms) x 1 scale and adjust zero if necessary. A) test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 Ω (ohm),...
Page 14
14 ignition system / gas ignition yes check plug top fuse and replace if necessary check polarity and earth continuity of supply point check earth continuity of appliance ignitor does not spark check fitting of burners check position of the electrode check by pass simmer light burner manually check ...
Page 15: To Adjust The Gas Rate
15 conversion from natural gas to lpg important the replacement/conversion of the gas hob should only be undertaken by a competent person. It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct inject...
Page 16
Grafiche mdm - forlì 35687-8602 04/06 customer care zanussi major appliances addington way luton bedfordshire lu4 9qq © electrolux plc 2003 www.Zanussi-electrolux.Co.Uk.