Zanussi ZGF 643 Instruction Booklet - 2. Cleaning and Maintenance

Manual is about: Zanussi Cooktop User Manual

Summary of ZGF 643

  • Page 1

    Notice d'utilisation gebruiksaanwijzing gebrauchsanleitung instruction booklet be table de cuisson gaskookplaat gaskochmulde gas hob zgf 643.

  • Page 2: English

    33 • this appliance has been designed to be operated by adults and children under supervision. Young children must not be allowed to tamper with the controls or play near or with the oven. • this appliance has been designed for cooking edible foodstuff and to be used for domestic non- professional p...

  • Page 3: 1. Instruction For The User

    34 1. Instruction for the user hob burners control knobs the hob burners control knobs are situated on the hob front panel. The symbols on the knobs mean that : ● there is no gas supply there is maximum gas supply there is minimum gas supply lighting the burners • for easier lighting, proceed before...

  • Page 4: 2. Cleaning and Maintenance

    35 fo 2237 fig. 2 fig. 3 fo 2238 2. Cleaning and maintenance • disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners frequently wash the "caps" and the "crowns" with ...

  • Page 5: 3. Technical Data

    36 fo 2365 3. Technical data gas burners rating rapid burner (big) 3 kw (g20) - 2,8 kw (g30-31) auxiliary burner (small) 1 kw semirapid burner (medium) 2 kw class 3 appliance category ii 2e+3+ setting natural gas 20 mbar / g25 25 mbar gas connection g 1/2" electric supply 230 v 50 hz hob recess dime...

  • Page 6: 5. Electrical Connection

    37 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rati...

  • Page 7

    38 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 7), and replace them with the ones required for the type of gas in use (see table 2). • reassemble the parts, following the same procedu- re bac...

  • Page 8: 7.  Building In

    39 fitting the lid we recommend the lid hinge block are fitted before installing the hob into the worktop. To install the lid onto the hob, proceed as follows: a. Remove the right and left hand grid blocks fitted to the back of the hob, by unscrewing the relevant screws (fig. 10) b. Fit the lid hing...

  • Page 9

    40 installation and assembly these hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in fig. 13. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the ...

  • Page 10

    41 480 30 591 380 140 360 cm 2 50 cm 2 120 cm 2 180 cm 2 30 20 min 60 a b possibilities for insertion kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recomm...

  • Page 11: Guarantee - Spare Parts

    42 when calling for repairs during the period of guarantee ofthe appliance, the original invoice or receipt must be shown or sent together with the appliance to be repaired. General conditions of guarantee 1 the manufacturer guarantees the appliance indicated on the relative invoice for a period of ...