Summary of ZGF 68
Page 2: Important Safety Information
12 guide to use the instructions the following symbols will be found in the text to guide you throughout the instructions: safety instructions step by step instructions for an operation hints and tips environmental information important safety information you must read hese warnings carefully before...
Page 3: Description of The Hob
13 1. Hob top 2. Auxiliary burner 3. Semi-rapid burners 4. Ultra-rapid triple-crown burner 5. Control knobs description of the hob this appliance complies with the following e.E.C. Directives: * 73/23 - 90/683 (low voltagedirective); * 93/68 (general directives); * 89/336 (electromagnetical compatib...
Page 4: Hob Burners
14 hob burners to light a burner: z turn the relevant control knob anticlockwise to the maximum position, then push it down to ignite the burner; z then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" and “crown” (see ...
Page 5: The Hob Top
15 before any maintenance or cleaning can be carried out, you must disconnect the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The hob top regularly wipe over the hob top using a soft cloth well w...
Page 6: Something Not Working?
16 something not working? If the hob is not working correctly, please carry out the following checks before contacting your local service force centre. Important: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made ...
Page 7: Engineers Technical Data
17 rear left burner (semi-rapid) heat input 2.0 kw (6824 btu/hr) front left burner (auxiliary) heat input 1.0 kw (3412 btu/hr) rear right burner (semi-rapid) heat input 2.0 kw (6824 btu/hr) front right burner: (ultra-rapid triple-crown) heat input 4.0 kw (13652 btu/hr) instructions for the installer...
Page 8: Provision For Ventilation
18 important safety requirements i clearances required when fitting the hob without a cooker hood above clearances required when fitting the hob with a cooker hood above fo 0813 fo 0812 700 mm this hob must be installed in accordance with the gas safety (installation and use) regulations (current ed...
Page 9: Gas Connection
19 a) end of shaft with nut b) washer c) elbow fo 0814 gas connection connection to the gas supply should be with either rigid or semi-rigid pipe, i.E. Steel or copper. The connection should be suitable for connecting to rc 1/2 (1/2 bsp male thread). When the final connection has been made, it is es...
Page 10: Commissioning
20 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from min to max several ti...
Page 11: Building In
21 fo 0763 fo 2564 fo 2044 1 2 3 fo 0199 a fitting the hob into the worktop ) carry out the building in of the hob as follows: • place the seals supplied with the hob on the side edges of the cut out and at 8 mm from the front and rear edges, as shown in the diagram, taking care that the seals meet ...
Page 12: Cut Out Size
22 rectangular cut-out size for hob cut out size the dimensions of the cut-out are given in the diagram. Fo 2038 100 dimensions are given in mm..
Page 13
23.
Page 14
Grafiche mdm - forlì 35692-6501 05/06 www.Electrolux.Com.