Zanussi ZGF 7521 Instruction Booklet

Summary of ZGF 7521

  • Page 1

    Zgf 7521 gas hob instruction booklet gb.

  • Page 2

    2 thank you for selecting our appliance thank you for selecting our appliance thank you for selecting our appliance thank you for selecting our appliance thank you for selecting our appliance we wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again whe...

  • Page 3

    3 contents important safety information important safety information important safety information important safety information important safety information ......................................................... ......................................................... ...............................

  • Page 4

    4 important safety information y y y y you must r ou must r ou must r ou must r ou must read these war ead these war ead these war ead these war ead these war nings car nings car nings car nings car nings carefully befor efully befor efully befor efully befor efully before installing or e installing...

  • Page 5

    5 z ensure the control knobs are in the ‘off’ position when not in use. Z when using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance. Z unstable or misshapen pans should not be used on the hob as unstable pans can cause an accid...

  • Page 6

    6 1. Hob top 2. Auxiliary burner 3. Semi-rapid burner 4. Rapid burner 5. Control knobs description of the hob 3 1 2 5 3 4 4.

  • Page 7

    7 installation any gas installation must be carried out by a registered any gas installation must be carried out by a registered any gas installation must be carried out by a registered any gas installation must be carried out by a registered any gas installation must be carried out by a registered ...

  • Page 8

    8 lighting the burners lighting the burners lighting the burners lighting the burners lighting the burners for easier lighting, proceed before putting a pan on the pan for easier lighting, proceed before putting a pan on the pan for easier lighting, proceed before putting a pan on the pan for easier...

  • Page 9: Burner

    9 burner minimum maximum diameter diameter large (rapid) 180 mm 260 mm medium (semi-rapid) 120 mm 220 mm small (auxiliary) 80 mm 160 mm as soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. Use only pans or pots with flat use only pans or pots with...

  • Page 10

    10 before any maintenance or cleaning can be carried out, before any maintenance or cleaning can be carried out, before any maintenance or cleaning can be carried out, before any maintenance or cleaning can be carried out, before any maintenance or cleaning can be carried out, you must disconnect th...

  • Page 11

    11 the burners the burners the burners the burners the burners the burner caps and crowns can be removed for cleaning. Wash the burners caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the...

  • Page 12

    12 something not working? If the hob is not working correctly, please carry out the following checks before contacting your local service force centre. Symptom symptom symptom symptom symptom there is no spark when lighting the gas. The gas ring burns unevenly. Solution solution solution solution so...

  • Page 13

    13 overall dimensions overall dimensions overall dimensions overall dimensions overall dimensions width: 680 mm depth: 510 mm cut out dimensions cut out dimensions cut out dimensions cut out dimensions cut out dimensions width: 560 mm depth: 480 mm thickness: 30 mm suppl suppl suppl suppl supply con...

  • Page 14

    14 burner rapid semi-rapid auxiliary (large) (medium) (small) position max min max min max min nominal thermal power kw 3.0 0.75 2.0 0.45 1.0 0.33 nominal flow rate m 3 /h 0.286 0.062 0.190 0.043 0.095 0.031 nozzle reference 119 adjust. 96 adjust. 70 adjust. Nominal thermal power kw 2.8 0.75 2.0 0.4...

  • Page 15

    15 important safety requirements this hob must be installed in accordance with the gas safety (installation and use) regulations (current edition) and the iee wiring regulations (current edition). For appliances installed in the republic of ireland please refer to nsai- domestic gas installation i.S...

  • Page 16

    16 installation impor impor impor impor impor t t t t tant ant ant ant ant this hob must be installed by a competent person to the this hob must be installed by a competent person to the this hob must be installed by a competent person to the this hob must be installed by a competent person to the t...

  • Page 17

    17 a) end of shaft with nut b) washer c) elbow fo 0264 it is important to install the elbow corr it is important to install the elbow corr it is important to install the elbow corr it is important to install the elbow corr it is important to install the elbow correctly ectly ectly ectly ectly, with ...

  • Page 18

    18 2 b b b b building over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit uilding over a kitchen unit with door with door with door with door with door proper arrangements must be taken in designing the furniture unit, in order to avoid any contact...

  • Page 19: Seal

    19 fitting the hob into the worktop carry out the building in of the hob as follows: • put the seals supplied with the hob, on the edges of the cut out: place them exactly on the front and rear edge and at 50 mm. From the side edges, as shown in the diagram, taking care that the seals meet without o...

  • Page 20

    20 electrical connections any electrical work required to install this hob should be any electrical work required to install this hob should be any electrical work required to install this hob should be any electrical work required to install this hob should be any electrical work required to instal...

  • Page 21

    21 wiring diagram permanent connection permanent connection permanent connection permanent connection permanent connection in the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm betwe...

  • Page 22

    22 fault finding preliminary electrical systems check preliminary electrical systems check preliminary electrical systems check preliminary electrical systems check preliminary electrical systems check s t a r t s t a r t s t a r t s t a r t s t a r t isolate appliance and carry out: a: a: a: a: a: ...

  • Page 23

    23 a. Earth continuity check a. Earth continuity check a. Earth continuity check a. Earth continuity check a. Earth continuity check appliance must be electrically disconnected - meter set on w (ohms) x 1 scale and adjust zero if necessary. — test leads from any appliance earth point to earth pin on...

  • Page 24

    24 check gas supply at burner ignition system / gas ignition ignition system / gas ignition ignition system / gas ignition ignition system / gas ignition ignition system / gas ignition yes yes yes yes yes check plug top fuse and replace if necessary check polarity and earth continuity of supply poin...

  • Page 25

    25 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. 1) turn the gas tap to the max position and ignite. 2) set the gas tap to the min flame position then turn the control knob from min to max several ...

  • Page 26

    26 conversion from natural gas to lpg impor impor impor impor import t t t tant ant ant ant ant the replacement/conversion from natural gas to lpg should only the replacement/conversion from natural gas to lpg should only the replacement/conversion from natural gas to lpg should only the replacement...

  • Page 27

    27 guarantee/customer service standard guarantee conditions standard guarantee conditions standard guarantee conditions standard guarantee conditions standard guarantee conditions we, zanussi-electrolux, undertake that if within 12 months of the date of the purchase this zanussi-electrolux appliance...

  • Page 28

    28 service and spare parts service and spare parts service and spare parts service and spare parts service and spare parts in the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local service force centre by telephoning 0870 5 929 929 0870 5 929...

  • Page 29

    29 this appliance is guaranteed by electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move w...

  • Page 30

    30

  • Page 31

    31.

  • Page 32

    356946902 10/07 r.0 www.Zanussi-electrolux.Co.Uk.