Summary of ZGF 78 ICX
Page 1
Gas hob zgf 78 icx instruction booklet please read this instruction booklet before using the appliance hr ro slo cz sk ru.
Page 2: Important Safety Information
2 important safety information guide to use the instructions the following symbols will be found in the text to guide you throughout the instructions: safety instructions step by step instructions for an operation hints and tips environmental information about installation, cleaning and manteinance ...
Page 3: Hob Burners Control Knobs
3 hob burners control knobs the hob burners control knobs are situated on the hob front panel. The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply lighting the burners • for easier lighting, proceed before putting a pan on the pan suppo...
Page 4: Cast Iron Pan Supports
4 fig. 2 fo 2238 disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any bui...
Page 5: Gas Burners Rating
5 gas burners rating ultra rapid burner (triple crown) 4,0 kw rapid burner (big) 2,8 kw semirapid burner (medium) 2,0 kw auxiliary burner (small) 1,0 kw class 3 appliance category ii 2h3+ setting natural gas g20 - 20 mbar gas connection g 1/2" electric supply 230 v 50 hz hob recess dimensions length...
Page 6: Gas Connection
6 the following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ...
Page 7: Electrical Connection
7 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the ratin...
Page 8: Injectors Replacement
8 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 8), and replace them with the ones required for the type of gas in use (see table 2). • reassemble the parts, following the same procedure backwa...
Page 9: Fitting The Lid
9 fitting the lid we recommend the lid hinge block are fitted before installing the hob into the worktop. To install the lid onto the hob, proceed as follows: a. Remove the right and left hand grid blocks fitted to the back of the hob, by unscrewing the relevant screws (fig. 11) b. Fit the lid hinge...
Page 10: Installation And Assembly
1 0 installation and assembly these hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in fig. 14. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the...
Page 11: Possibilities For
1 1 possibilities for insertion kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in fig. 17. The panel fitted under the hob sho...