- DL manuals
- Zanussi
- Hob
- ZGF 7820
- Instruction Booklet
Zanussi ZGF 7820 Instruction Booklet
Summary of ZGF 7820
Page 1
Gas hob zgf 7820 instruction booklet please read this instruction booklet before using the appliance gb.
Page 2: Important Safety Information
2 important safety information you must read these warnings carefully before installing or using the hob. If you need assistance, contact our customer care department on 08705 727727 installation z this appliance must be installed and serviced by a competent person as stated in the gas safety (insta...
Page 3: For The User
3 for the user contents for the installer important safety information 2 description of the hob 4 operation 5 maintenance and cleaning 5 something not working? 6 guarantee/customer service 15 instructions for the installer 7 important safety requirements 8 installation 9 building in 10 electrical co...
Page 4: Description of The Hob
4 1. Auxiliary burner 2. Semi-rapid burners 3. Ultra-rapid triple-crown burner 4. Rapid burner 5. Control knobs description of the hob 2 1 4 3 2 5.
Page 5: Maintenance and Cleaning
5 maintenance and cleaning operation hob burners to light a burner: z push in the relevant control knob and turn it anticlockwise to maximum position; z then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again. To ensure maximum burner efficiency...
Page 6: Something Not Working?
6 something not working? If the hob is not working correctly, please carry out the following checks before contacting your local zanussi service force centre. Symptom there is no spark when lighting the gas the gas ring burns unevenly solution check that the unit is plugged in and the electrical sup...
Page 7: Engineers Technical Data
7 overall dimensions width: 680 mm depth: 510 mm cut out dimensions width: 560 mm depth: 480 mm supply connections gas: r 1/2 inch (1/2 inch male) rear right hand corner electric: 230-240 v 50 hz supply, 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse. Ignition ht s...
Page 8: Provision For Ventilation
8 fitting the gas hob without a cooker hood above fitting the gas hob with a cooker hood above 700 mm 400 mm 400 mm 100 mm 55 mm 50 mm 50 mm 600 mm 700 mm 400 mm 400 mm 100 mm 55 mm 600 mm 50 mm 50 mm fo 2369* fo 2231* important safety requirements this hob must be installed in accordance with the g...
Page 9: Installation
9 installation important: this hob must be installed by a competent person to the relevant gas standards. Any gas installation must be carried out by a competent person. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in ...
Page 10: Building In
10 f o 2564 fo 2044 3 dimensions are given in mm. Building in building over a cupboard or drawer if the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recommended to carry...
Page 11: Electrical Connections
11 electrical connections any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. This hob must be earthed. The manufacturer declines any liability should these safety measures not be observed....
Page 12: Fault Finding
12 fault finding preliminary electrical systems check a. Earth continuity check - appliance must be electrically disconnected - meter set on Ω (ohms) x 1 scale and adjust zero if necessary. A) test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 Ω (ohm),...
Page 13
13 ignition system / gas ignition yes check plug top fuse and replace if necessary check polarity and earth continuity of supply point check earth continuity of appliance ignitor does not spark check fitting of burners check position of the electrode check by pass simmer adjusted light burner manual...
Page 14: Commissioning
14 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from min to max several ti...
Page 15: Guarantee/customer Service
15 guarantee/customer service standard guarantee conditions we, zanussi-electrolux, undertake that if within 12 months of the date of the purchase this zanussi-electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option...
Page 16: European Guarantee
16 this appliance is guaranteed by electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move w...
Page 17
17.
Page 18
18.
Page 19
19.
Page 20
35687-8702 11/06 grafiche mdm - forlì www.Zanussi-electrolux.Co.Uk.