Summary of ZGF 98
Page 2: Important Safety Information
12 important safety information installation z this appliance must be installed and serviced by a competent person as stated in the gas safety (installation and use) regulations current editions and the iee wiring regulations. Z remove all packaging before using the hob. Z ensure that the gas and el...
Page 3: For The User
13 this appliance complies with the following e.E.C. Directives: * 73/23 - 90/683 (low voltagedirective); * 93/68 (general directives); * 89/336 (electromagnetical compatibility directive); * 90/396 (gas appliances), and subsequent modifications for the user contents for the installer description of...
Page 4: Operation
14 operation hob burners to light a burner: z turn the relevant control knob anticlockwise to the maximum position, then push it down to ignite the burner; z then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" and “cr...
Page 5: Maintenance and Cleaning
15 maintenance and cleaning before any maintenance or cleaning can be carried out, you must disconnect the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The hob top regularly wipe over the hob top ...
Page 6: Something Not Working?
16 something not working? If the hob is not working correctly, please carry out the following checks before contacting your local service force centre. Symptom there is no spark when lighting the gas the gas ring burns unevenly solution check that the unit is plugged in and the electrical supply is ...
Page 7: Engineers Technical Data
17 overall dimensions width: 860 mm depth: 510 mm cut out dimensions width: 830 mm depth: 480 mm supply connections gas: r 1/2 inch (1/2 inch male) rear right hand corner electric: 220 v 50 hz supply, 3 core flexible cable with non rewireable plug. Rear left burner (semi rapid) heat input 2.0 kw fro...
Page 8: Provision For Ventilation
18 fitting the gas hob without a cooker hood above fitting the gas hob with a cooker hood above 700 mm 400 mm 400 mm 100 mm 55 mm 50 mm 50 mm 600 mm 700 mm 400 mm 400 mm 100 mm 55 mm 600 mm 50 mm 50 mm fo 2369* fo 2231* important safety requirements this hob must be installed in accordance with the ...
Page 9: Installation
19 installation important: this hob must be installed by a competent person to the relevant gas standards. Any gas installation must be carried out by a competent person. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in...
Page 10: Commissioning
20 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from min to max several ti...
Page 11: Building In
21 f o 2564 fo 2044 3 dimensions are given in mm. Building in building over a cupboard or drawer if the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recommended to carry...
Page 14
Grafiche mdm - forlì 35692-6601 am 05/06.