1. DL manuals
  2. Zanussi
  3. Hob
  4. ZGF782C
  5. Instruction Booklet

Zanussi ZGF782C Instruction Booklet

Manual is about: ZANUSSI INSTRUCTION GAS HOB ZGF782C

Summary of ZGF782C

  • Page 1

    Gas hob zgf782c instruction booklet please read this instruction booklet before using the appliance gb.

  • Page 2

    2 this appliance complies with the following e.E.C. Directives: * 73/23 - 90/683 (low voltagedirective); * 93/68 (general directives); * 89/336 (electromagnetical compatibility directive); * 90/396 (gas appliances), and subsequent modifications important safety information you must read hese warning...

  • Page 3

    3 for the user contents for the installer 1. Auxiliary burner 2. Semi-rapid burners 3. Ultra-rapid triple-crown burner 4. Rapid burner 5. Control knobs description of the hob important safety information 2 description of the hob 3 operation 4 maintenance and cleaning 4 something not working? 5 guara...

  • Page 4

    4 maintenance and cleaning operation hob burners to light a burner: l push in the relevant control knob and turn it anticlockwise to maximum position; l then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again. To ensure maximum burner efficiency...

  • Page 5

    5 something not working? If the hob is not working correctly, please carry out the following checks before contacting your local zanussi service force centre. Symptom n there is no spark when lighting the gas n the gas ring burns unevenly solution u check that the unit is plugged in and the electric...

  • Page 6

    6 in the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local zanussi service force centre by telephoning: 0870 5 929929 your telephone call will be automatically routed to the service force centre covering your post code area. For the address ...

  • Page 7

    7 overall dimensions width: 680 mm. Depth: 510 mm. Cut out dimensions width: 560 mm. Depth: 480 mm. Supply connections gas: r 1/2 inch (1/2 inch male) rear right hand corner electric: 230-240v 50hz supply, 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse. Ignition ht...

  • Page 8

    8 fitting the gas hob without a cooker hood above fitting the gas hob with a cooker hood above 700 mm 400 mm 400 mm 100 mm 55 mm 50 mm 50 mm 600 mm 700 mm 400 mm 400 mm 100 mm 55 mm 600 mm 50 mm 50 mm fo 2369* fo 2231* important safety requirements this hob must be installed in accordance with the g...

  • Page 9

    9 installation important: this hob must be installed by qualified personnel to the relevant british standards. Any gas installation must be carried out by a registered corgi installer. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions i...

  • Page 10

    10 fo 2564 fo 2044 3 50 50 fo 2039 dimensions are given in mm. Building in building over a cupboard or drawer if the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recomme...

  • Page 11

    11 electrical connections any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. This hob must be earthed. The manufacturer declines any liability should these safety measures not be observed....

  • Page 12

    12 fault finding preliminary electrical systems check a. Earth continuity check - appliance must be electrically disconnected - meter set on w (ohms) x 1 scale and adjust zero if necessary. A) test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 w (ohm),...

  • Page 13

    13 ignition system / gas ignition yes check plug top fuse and replace if necessary check polarity and earth continuity of supply point check earth continuity of appliance ignitor does not spark check fitting of burners check position of the electrode check by pass simmer adjusted light burner manual...

  • Page 14

    14 commissioning when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from min to max several ti...

  • Page 15

    15.

  • Page 16

    35669-7305 02/03 grafiche mdm - forlì customer care zanussi 55-77 high street slough berkshire, sl1 1dz tel: 08705 727727 © electrolux plc 2003 from the electrolux group. The world’s no.1 choice. The electrolux group is the world’s largest producer of powered appliances for kitchen, cleaning and out...