Summary of ZGG649
Page 1
Instruction booklet gas hob zgg 649 3567 0-8203.
Page 2: Important Safety Information
2 important safety information you must read these warnings carefully before installing or using the appliance. Installation ! This appliance must be installed by qualified personnel, according to the manufacturer’s instructions and to the rules in force. ! Remove all packaging before using the appl...
Page 3: For The User
3 for the user description of the appliance 4 operation 5 maintenance and cleaning 5 something not working? 6 contents for the installer technical data 6 installation 7 gas connection 7 building in 8 fitting the hob to the worktop 9 electrical connection 9 commissioning 10 servicing 11 technical mai...
Page 4
4 description of the appliance installation any gas installation must be carried out by qualified personnel, and in accordance with existing rules and regulations. The relevant instructions are to be found in the second section of this manual. Please, ensure that, once the appliance is installed, it...
Page 5: Operation
5 to light a burner, turn the relevant control knob anticlockwise to maximum position and push it down to ignite. Keep the control knob pressed down for about 5 seconds, to allow the safety device to be switched off. Then adjust the flame as required. If the burner does not ignite, turn the control ...
Page 6: Something Not Working?
6 overall dimensions width: 580 mm. Depth: 510 mm. Height: 88 mm. Weight: 9,8 kg. Instructions for the installer cut out dimensions width: 550 mm. Depth: 470 mm. Thickness: 40 mm. Supply connections gas: rc 1/2 inch (1/2 inch male) rear right hand corner electric: 230-v 50hz supply, 3 core flexible ...
Page 7: Installation
7 550 470 580 510 55 min. A) end of shaft with nut b) washer c) adjustable joint installation important this appliance must be installed by qualified personnel. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book...
Page 8: Building In
8 building in fo 1013 building over a cupboard or drawer if the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. Building over a kitchen unit with door proper arrangements must be take...
Page 9: Fitting The Hob to
9 before fitting the hob into the cut out, an adhesive seal must be fitted to the underside outside edge of the hob. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below. 1) remove the pan supports, the burners caps and crowns an...
Page 10: Commissioning
10 commissioning fig. 8 by-pass screw when the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - turn the gas tap to the max position and ignite. - set the gas tap to the min flame position then turn the control knob from ...
Page 11: Servicing
11 servicing a: removal of hob top 1. Remove the panstands and each burner cap and crown. 2. Lift the hob from off the working top. 3. Remove the two self tapping screws from each burner and the two fixing screws on the right hand side of the hob. B: removal of the hob taps (isolate electric supply)...
Page 12: Technical Maintenance
12 technical maintenance check at regular intervals the condition and serviceability of the gas connection hose and pressure regulator, if any is fitted; in case of malfunction, do not repair but replace the whole faulty part. To ensure a smooth and safe operation, it is necessary to periodically gr...