Summary of ZGG65414
Page 1
En user manual gas hob zgg65414 ie gb.
Page 2: Contents
Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 product description _ _ _ _ _ _ _ _ _ _ _ _ _ 8 operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ 9 care and cleaning _ _ _ _ _ _ _ _ _ _ _ ...
Page 3
And that it is centrally positioned on the rings in order to avoid safety risks. • do not use unstable cookware or cookware with damaged bottom. There is a risk of tilt- ing and accident. • do not put flammable products or items that are wet with flammable products, fusible ob- jects (made of plasti...
Page 4: Installation
• disconnect the appliance from the elec- trical supply, before you do the mainte- nance work or you clean it. • the electrical mains terminal is live. • make electrical mains terminal free of volt- age. • install correctly to give anti-shock protection. • a loose and incorrect mains plug and socket...
Page 5
Edges of the hob is 400 mm. If it is fitted below 400 mm a space of 50 mm must be allowed from the edges of the hob. For appliances installed in the republic of ire- land please refer to nsai- domestic gas in- stallation i.S 813 current edition section 7- permitted locations of appliance. Gas connec...
Page 6
4. With a thin screwdriver, adjust the by-pass screw position. 1 1 the by-pass screw – if you change from natural gas g20 20 mbar to liquid gas, fully tighten the ad- justment screw in. – if you change from liquid gas to natural gas g20 20 mbar, undo the by-pass screw approximately 1/4 of a turn. Wa...
Page 7
1 2 3 4 5 1 green and yellow 2 3 amp fuse 3 brown 4 cord clamp 5 blue should the plug need to be replaced for any reason, the wires in the mains lead are coloured in accordance with the following code: green and yellow - earth blue - neutral brown - live 1. Connect the green and yellow (earth) wire ...
Page 8: Product Description
Min 20 mm (max 150 mm) 30 mm 60 mm b a a) removable panel b) space for connections kitchen unit with oven the hob recess dimensions must obey the indi- cation and the kitchen unit must be equipped with vents to let a continuous supply of air. The electrical connection of the hob and the oven must be...
Page 9: Helpful Hints and Tips
2. Keep the control knob pushed for approxi- mately 5 seconds; this will let thermocou- ple to warm up. If not, the gas supply will be interrupted. 3. Adjust the flame after it is regular. If after some tries the burner does not light, check if the crown and its cap are in correct positions. 3 4 2 1...
Page 10: Care And Cleaning
Do not place unstable or deformed pots on the rings to prevent from spill and injury. Warning! Flame diffuser are not recommended. Information on acrylamides important! According to the newest scientific knowledge, if you brown food (specially the one which contains starch), acrylamides can pose a h...
Page 11: What To Do If…
Ing and check that the burner crown holes are not obstructed. Periodic maintenance periodically speak your local service force centre to check the conditions of the gas sup- ply pipe and the pressure adjuster, if fitted. What to do if… problem possible cause remedy there is no spark when lighting th...
Page 12: Technical Data
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local service force centre. If you operated the appliance incorrectly, or the installation was not carried out by a registered engineer, the visi...
Page 13: By-Pass Diameters
Electric supply: 230 v ~ 50 hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse gas connection: g 1/2 " category: ii2h3+ gas supply: g20 (2h) 20 mbar appliance class: 3 by-pass diameters burner Ø by-pass in 1/100 mm auxiliary 28 semi-rapid 32 rapid 42 gas burners bur...
Page 14
14 www.Zanussi.Com.
Page 15
15 www.Zanussi.Com.
Page 16
Www.Zanussi.Com/shop 397 225801-b-152 012.