Zanussi ZGL 66 Instruction Booklet - About Installation, Cleaning

Summary of ZGL 66

  • Page 1

    Instruction booklet rukovodstvo po ékspluatacii gas hobs zgl 66 zxl 66 ru varoqn y e poverxnosti gazov y e.

  • Page 2

    2.

  • Page 3: About Installation, Cleaning

    3 about installation, cleaning and manteinance • it is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. • disconnect the appliance from the electrical supply, before carrying out any cle...

  • Page 4: Hob Burners Control Knobs

    4 once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. Hob burners control knobs the hob burners control knobs are situated on the hob right hand side. The symbols on the knobs mean that: there is no gas supply there is maximum gas su...

  • Page 5: Using The Hob Correctly

    5 burner minimum maximum diameter diameter big (rapid) 160 mm. 260 mm. Medium (semirapid) 120 mm. 220 mm. Small (auxiliary) 80 mm. 160 mm. Using the hob correctly to ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the bur...

  • Page 6: Cleaning and Maintenance

    6 cleaning and maintenance disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. General cleaning wash the enamelled components with warm soapy water. Never use abrasive cleaners. Frequently wash the "caps" and the "crowns" with hot soapy water, c...

  • Page 7: Gas Burners Rating

    7 gas burners rating rapid burner 3,0 kw (g20) - 2,8 kw (g30/g31) semirapid burner 2,0 kw auxiliary burner 1,0 kw appliance class 3 category ii 2h3+ setting zgl 66: natural gas g 20 / 20 mbar zxl 66: lpg g30/g31 28-30/37 mbar gas connection g 1/2" • the following instructions about installation and ...

  • Page 8: Electrical Connection

    8 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the ratin...

  • Page 9: Injectors Replacement

    9 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 7), and replace them with the ones required for the type of gas in use (see table 2). • reassemble the parts, following the same procedu- re back...

  • Page 10: Building In

    1 0 these hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in the relevant diagram. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the h...

  • Page 11: Kitchen Unit With Door

    1 1 a) removable panel b) space possibly useful for connections 550 min. 560 min. Fig. 11 fig. 12 fig. 14 fig. 15 fo 1013 fo 0947 fo 0198 kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be he...