Zanussi ZGL640TW User Manual

Other manuals for ZGL640TW: User Manual

Summary of ZGL640TW

  • Page 1

    En user manual hob zgl640tw gb.

  • Page 2: Contents

    Contents safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 product description _ _ _ _ _ _ _ _ _ _ _ _ _ 5 daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ 6 care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _...

  • Page 3: Safety

    • unattended cooking on a hob with fat or oil can be dangerous and may result in fire. • never try to extinguish a fire with water, but switch off the appli- ance and then cover flame e.G. With a lid or a fire blanket. • do not store items on the cooking surfaces. • do not use a steam cleaner to cle...

  • Page 4

    Moved from the holder), earth leakage trips and contactors. Gas connection • all gas connections should be made by a qualified person. • make sure that there is air circulation around the appliance. • the information about the gas supply is on the rating plate. • this appliance is not connected to a...

  • Page 5: Product Description

    Abrasive products, abrasive cleaning pads, solvents or metal objects. Disposal warning! Risk of injury or suffocation. • contact your municipal authority for informa- tion on how to discard the appliance correct- ly. • disconnect the appliance from the mains supply. • cut off the mains cable and dis...

  • Page 6: Helpful Hints And Tips

    If after some tries the burner does not light, check if the crown and its cap are in correct positions. A b c d a) burner cap b) burner crown c) ignition candle d) thermocouple warning! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, relea...

  • Page 7: Care And Cleaning

    Do not put unstable or damaged pots on the rings to prevent from spill and injury. Warning! Do not use a flame diffuser. Care and cleaning warning! Refer to the safety chapters. Warning! Deactivate the appliance and let it cool down before you clean it. Disconnect the appliance from the electrical s...

  • Page 8: Troubleshooting

    Troubleshooting problem possible cause remedy there is no spark when lighting the gas • there is no electrical supply • make sure that the unit is con- nected and the electrical supply is switched on. • control the fuse. If the fuse is released more than one time, refer to a qualified electrician. •...

  • Page 9: Installation

    If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local service force centre. If you operated the appliance incorrectly, or the installation was not carried out by a registered engineer, the visi...

  • Page 10

    Provision for ventilation detailed recommendations are contained in the following british standards codes of practice: b.S. 6172/ b.S. 5440, par. 2 and b.S. 6891 current editions. The hob should not be installed in a bed sitting room with a volume of less than 20 m³. If it is installed in a room of ...

  • Page 11

    Rigid connection: carry out connection by using metal rigid pipes (copper with mechanical end). Injectors replacement 1. Remove the pan supports. 2. Remove the caps and crowns of the burn- er. 3. With a socket spanner 7 remove the injec- tors and replace them with the ones which are necessary for th...

  • Page 12

    2. The supply system is equipped with an effi- cient earth connection in compliance with the current standards and regulations 3. The outlet or omnipolar switch used for connection is easily accessible with the appliance installed. The appliance is supplied with a 3 core flexible powercable with a 3...

  • Page 13: Technical Information

    A b a) supplied seal b) supplied bracket caution! Install the appliance only on a worktop with flat surface. Possibilities for insertion kitchen unit with door the panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. Mi...

  • Page 14: By-Pass Diameters

    Gas supply: g20 (2h) 20 mbar appliance class: 3 by-pass diameters burner Ø by-pass in 1/100 mm auxiliary 28 burner Ø by-pass in 1/100 mm semi-rapid 32 rapid 42 gas burners burner normal power re- duced power normal power natural gas g20 (2h) 20 mbar lpg (butane/propane) g30/g31 (3+) 28-30/37 mbar kw...

  • Page 15

    15 www.Zanussi.Com.

  • Page 16

    Www.Zanussi.Com/shop 397 195002-a-492 012.