Gas hob ГАЗОВАЯ ВАРОЧНАЯ ПОВЕРxНОcТЬ zglr 646 operating and installation manual РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ it ru.
2 important safety information about installation, cleaning and manteinance • it is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. • disconnect the appliance from the electrical supply...
3 guide to use the instructions the following symbols will be found in the text to guide you throughout the instructions: safety instructions step by step instructions for an operation hints and tips environmental information ! ! ! ! ! These instructions are only for the countries stated by the symb...
4 hob burners control knobs the hob burners control knobs are situated on the hob front panel. The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply lighting the burners • for easier lighting, proceed before putting a pan on the pan suppo...
5 disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. ...
6 this machine, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention. For this reason we recommend that for any problem you conta...
7 instruction for the installer " " " " " the following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. " " " " " the appliance must be electrically disconnected before all interventions. If any electric supply to...
8 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the ratin...
9 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 5), and replace them with the ones required for the type of gas in use (see table "injectors"). • reassemble the parts, following the same proced...
1 0 installation and assembly the hob can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in fig. 8. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the cut...
1 1 fig. 9 fig. 10 fig. 11 fig. 12 possibilities for insertion kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in fig. 10. The...
