Zanussi ZGM 78 ITX Instruction Booklet

Summary of ZGM 78 ITX

  • Page 1

    Gas hob zgm 78 itx instruction booklet please read this instruction booklet before using the appliance hr ro slo cz sk.

  • Page 2

    2 important safety information guide to use the instructions the following symbols will be found in the text to guide you throughout the instructions: safety instructions step by step instructions for an operation hints and tips environmental information f about installation, cleaning and manteinanc...

  • Page 3: Contents

    3 hob burners control knobs the hob burners control knobs are situated on the hob front panel. The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply lighting the burners • for easier lighting, proceed before putting a pan on the pan suppo...

  • Page 4

    4 disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. ...

  • Page 5

    5 this machine, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention. For this reason we recommend that for any problem you conta...

  • Page 6: Gas Connection

    6 instruction for the installer l the following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. L the appliance must be electrically disconnected before all interventions. If any electric supply to the appliance i...

  • Page 7

    7 the appliance is designed to be connected to 230 v monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the ratin...

  • Page 8

    8 injectors replacement • remove the pan supports. • remove the burner's caps and crowns. • with a socket spanner 7 unscrew and remove the injectors (fig. 5), and replace them with the ones required for the type of gas in use (see table 2 ). • reassemble the parts, following the same procedure backw...

  • Page 9

    9 installation and assembly these hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in fig. 8. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the cu...

  • Page 10

    10 480 30 591 380 140 360 cm 2 50 cm 2 120 cm 2 180 cm 2 30 20 min 60 a b possibilities for insertion kitchen unit with door proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recomm...

  • Page 11

    11.

  • Page 12

    35678-8601 01/03 grafiche mdm - forlì from the electrolux group. The world’s no.1 choice. The electrolux group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million electrolux group products (such as refrigerators, cookers, washing machines...