Zanussi ZGS 645 Operating Instructions Manual - Building In

 17

Building In

These hobs can be inserted in a built-in

kitchen unit whose depth is between 550 and

600 mm. The hobs dimensions are shown in

Fig. 4.

The edge of the cut out must have a mini-

mum distance from the rear wall of 55 mm.

If there are side walls, or sides of the

furniture unit near the hob, the cut out edges

must have a minimum distance of 150 mm.

Hanging forniture units or hoods must be

placed at 650 mm. minimum from the hob.

Fitting the hob to the worktop

Carry out the building in of the hob as

follows:

1. Place the seals supplied with the hob on the

front edge of the cut out. Then, place them

at 11 mm from the side edges and at 10 mm

from the rear edge, as shown in the

diagram, taking care that the seals meet

without overlapping.

2. Place the hob in the cut out, taking care that

it is centred.

A = Auxiliary burner

SR = Semi-rapid burner

R = Rapid burner

TC = Triple Crown burner

Fig. 5

Dimensions are given in millimeters

R

SR

A

SR

510

594

TC

SR

A

SR

510

594

ZGS 645

ZGS 685